Skip to content

Structural Analysis

CE · Midterm · Fall 24

Section BN1, BN2

This browser can’t show the PDF here

Open it, and your phone’s PDF viewer takes it, or download it.

Read the questions as text

Read off the PDF by AI, so it may have mistakes. The PDF is the original.

Daffodil International University B. Sc. in Civil Engineering Midterm Examination, Fall - 2024 Course Code: CE 311 Course Title: Structural Analysis Teacher's Initial: MR Section: BN1, BN2 Level-Term: 3-1 Time: 1.5 Hours Full Marks: 25 Date: September 30, 2024 Note: There are three questions in total. Answer all of them. Assume any reasonable value if not provided. The figures in the right-hand margin indicate full marks. 1. a). Calculate the maximum shear force and maximum moment at point "C" of a simply supported beam having 60 ft length due to the multiple wheel loads as shown in Figure-01. [CO3, C3] [06] [Figure: A simply supported beam of 60 ft length with supports at A and B, point C is between them. Multiple wheel loads of 10 kip, 35 kip, 35 kip, 30 kip, 30 kip and a uniform load of 0.72 kip/ft are shown above the beam.] b). Illustrate the influence lines with ordinate for the beam shown in Figure-02. [CO3, C3] [04] (i) Vertical reactions at points B and D, (ii) Shear forces at just left and right of support D, (iii) Vertical reaction at point D and shear force at point E and (iv) Moments at C and E. [Figure: A continuous beam with supports at A, B, D, F, G and hinges at C, E with specified lengths between points.] 2. a). Calculate the vertical displacement of joint A of the truss shown in Figure-03 using the method of virtual work. Each bar is made of steel and has a cross-sectional area of 600 mm^2 and E = 200 GPa. [CO4, C4] [06] The virtual-work equation for the truss is, 1.Δ = ∑ nNL / AE [Figure: A truss supported by a pin at B and roller at D, loaded with a 5 kN vertical downward force at A. Dimensions are provided.] b). Calculate the displacement of point B of the steel beam shown in Figure-04 using the method of virtual work. Take I = 500x10^6 mm^4 and E = 200 GPa. [CO4, C4] [04] The virtual-work equation for the beam is, 1.Δ = ∫ (m M / EI) dx [Figure: A simply supported beam of 10 m length under a uniform load of 12 kN/m with supports A and B.] 3. Explain external, internal and geometrical stability and determinacy of the structures shown in Figure-05. Also identify the DOI of the indeterminate structures. [CO1, C2] [05] [Figure: Five structural systems labeled (i) to (v) showing various frames and beams with supports and internal members.]