Digital Electronics and Logic Design
SWE · Midterm · Fall 26
Read the questions as text
Read off the PDF by AI, so it may have mistakes. The PDF is the original.
Daffodil International University
Faculty of Science & Information Technology
Department of Software Engineering
Midterm Examination, Fall_2026
Course Code: SE 213; Course Title: Digital Electronics & Logic design
Sections & Teachers: SP, MTE, RHA, SPB, Batch and Section: 47 (A-H)
Time: 1:30 Hrs
Marks: 25
Answer ALL Questions
[The figures in the right margin indicate the full marks and corresponding course outcomes. All portions of each question must be answered sequentially.]
1 a) Convert the following numbers: [Marks-3] CLO-1 Level-2
(9AF3.31A)16 + (1011101.1101)2 = (?)10
1 b) Subtract binary number the following using 2's complement: [Marks-2]
i) (31)10 - (63)10
1 c) A robotic welding cell is controlled by a small digital circuit. The circuit reads three sensors and drives the welding torch and a warning light. [Marks- 5]
Inputs:
A = 1 if the safety door is closed;
B = 1 if the operator is inside the work zone;
C = 1 if the workpiece is clamped.
Outputs: W (welding torch ON), L (warning light ON).
(1) The torch stays OFF if the workpiece is not clamped, or if the operator is inside the work zone while the door is closed, or if the operator is inside the work zone while the door is open. In every other situation, the torch turns ON.
(2) The warning light turns ON if the workpiece is not clamped and the door status and the operator's position are "in agreement" (the door is closed and the operator is inside, or the door is open and the operator is outside). The light also turns ON if the workpiece is clamped, the door is closed and the operator is inside.
Express the Boolean expression for each output, and then:
i) Simplify each expression.
ii) Draw the circuit diagram of the simplified expressions using AND, OR and NOT gates as required.
2 a) ii) Apply Parallel full adder to Compute (H + I) the following operation along with diagram: Where H = 1 1 0 0 1 1 and I = 1 1 0 0 [Marks-4] CLO-2 Level-3
2 b) i) F (Q, R, S) = ∑ (0, 1, 2, 4, 5, 6) [Marks-3]
Apply k-map simplification technique to simplify the above expressions.
Construct the logic diagrams of the simplified output.
2 c) F (A, B, C, D) = C'(A'BD'+D') +AB'C+BD' [Marks-8]
Apply k-map simplification technique to simplify the above expressions.
Construct the logic diagrams of the simplified output.