Physics II
CSE · Midterm · Fall 25
Batch 68
Read the questions as text
Read off the PDF by AI, so it may have mistakes. The PDF is the original.
Daffodil International University
Faculty of Science & Information Technology
Department of Computer Science & Engineering
Midterm Examination, Fall 2025
Course Code: PHY102, Course Title: Physics II
Level: 1 Term: 3 Batch: 68
Time: 01:30 Hrs
Marks: 25
Answer ALL Questions
[The figures in the right margin indicate the full marks and corresponding course outcomes. All portions of each question must be answered sequentially.]
1. a) Identify the limitations of Coulomb's Law. | 1 | CO1
1. b) State Ampère's Law. | 1 |
1. c) Relate drift velocity with current density. | 1 |
1. d) Recall the concept "Lorentz Force". | 1 |
1. e) Distinguish between resistivity and conductivity. | 1 |
2. a) A father teaches his daughter how to protect sensitive equipment from high current by using a low resistance in parallel. Explain how this protects the equipment and determine the current flowing through the low resistance. | 3 | CO2
2. b) An engineer is designing a touch sensor using two flat metal plates placed parallel to each other with a thin insulating layer in between. Demonstrate the capacitance of this type of capacitors. | 3 |
2. c) During an electronics workshop, a technician notices that a compass needle deflects near a long, straight current-carrying wire. Using the Biot-Savart law, derive the expression for the magnetic field at a distance r from the wire carrying a steady current I. | 4 |
3. a) A copper wire of cross-sectional area 1 mm^2 carries a current of 10 A. If the number of free electrons per cubic meter is 1 × 10^28, determine a) the drift velocity of the electrons, and b) the current density. | 2.5 | CO3
3. b) A large, non-conducting sheet carries a uniform surface charge density of sigma = 3 × 10^-6 C/m^2. a) Calculate the electric field intensity near the surface of the sheet. b) If a test charge of q = 2 × 10^-9 C is placed at some distance from the sheet, determine the magnitude of the electrostatic force acting on it. | 2.5 |
3. c) The magnetic flux through a flat surface of area 40 cm^2 in a uniform magnetic field of 1.2 T is 2.4 × 10^-3 Wb. What is the angle (in radians) between the plane and the magnetic field? | 2.5 |
3. d) The primary coil of a transformer has 200 turns and is connected to a 120 V supply. If the secondary coil has 800 turns, determine the secondary voltage. | 2.5