Instrumentation and Control
CSE · Midterm · Spring 26
Batch 64
Read the questions as text
Read off the PDF by AI, so it may have mistakes. The PDF is the original.
Daffodil International University
Faculty of Science & Information Technology
Department of Computer Science & Engineering
Midterm Examination, Spring 2026
Course Code: CSE 325, Course Title: Instrumentation and Control
Level: 4 Term: 1 Batch: 64
Time: 1:30 Hrs
Marks: 25
Answer ALL Questions
[The figures in the right margin indicate the full marks and corresponding course outcomes. All portions of each question must be answered sequentially.]
1. a) Differentiate between active sensors and passive sensors with suitable examples. [1] CO1
b) State meter loading effect. [1] CO1
c) Define poles and zeros of a transfer function. [1] CO1
d) Recall the reasons why RTDs are preferred over thermocouples for precision measurement. [1] CO1
e) List two advantages of electronic instruments. [1] CO1
2. a) Explain the construction and operating principle of a Current Transformer (CT). Analyze why the secondary winding of a Current Transformer (CT) should never be left open while the primary is energized. [5] CO2
b) Solve the circuit in Figure 2(b) to find out the transfer function, V2(s)/V1(s). [5] CO2
[Figure: Circuit diagram showing input voltage V1(s), resistors R, R2, capacitor C, and current nodes]
3. a) Design the equivalent single transfer function of the control system shown in Figure 3(a) by systematically reducing the block diagram. [5] CO3
[Figure: Block diagram of a control system with blocks G1(s), G2(s), G3(s), H1(s), H2(s), H3(s) and feedback/feedforward summing points]
b) In the circuit shown in Figure 3(b), the voltage across the resistor of value 25 kΩ is to be measured using a voltmeter of sensitivity 2 kΩ/V and the range of the meter is 0-150 V. Determine the reading of the voltmeter in each case and the percentage error in the measurement. [5]
[Figure: DC circuit with a 250 V source, resistors R1 = 20 kΩ and R2 = 25 kΩ, and a voltmeter connected across R2]