Skip to content

Mechanics of Solids II

CE · Midterm · Spring 26

Section A, B, C

This browser can’t show the PDF here

Open it, and your phone’s PDF viewer takes it, or download it.

Read the questions as text

Read off the PDF by AI, so it may have mistakes. The PDF is the original.

Daffodil International University B. Sc. in Civil Engineering Midterm Examination, Spring - 2026 Course Code: CE 213 Course Title: Mechanics of Solids II Section: A, B, C Level-Term: 2-2 Teacher's Initial: SAR, JD Full Marks: 25 Date: February 22, 2026 Time: 1.5 Hours Note: Answer all the questions. Assume any reasonable value if not provided. Right hand margin indicates full marks. 1. a) Prove that, in case of plane stress the sum of the normal stresses exerted on a cubic element of material is independent of the orientation of that element. [CO1, C5] σ'x + σ'y = σx + σy b) The current state of element with plane stress with respect to xy- axes can be shown in the Fig 2. Determine the following- i. The state of stress with respect to x'y' axes, ii. The principal stresses and principal planes, iii. The maximum in plane shear stress. Then show the stress values on properly oriented stress blocks. [CO1, C5] [Figure: A stress element subjected to normal stresses of 100 MPa, 250 MPa and shear stress of 100 MPa oriented at 20 degrees] c) The bent bar shown in Fig 3. Is 200 mm square. Determine the normal stresses at A and B. [CO1, C5] [Figure: A bent bar loaded with a 450 kN force, with dimensions 500 mm, 400 mm, 100 mm, and 300 mm] d) Determine the flexural stress at each corner point of the column as shown in Fig 4. [05] [CO1, C5] [Figure: A 3D column subjected to an 85 kN load at the top corner, with cross-section dimensions 280 mm and 120 mm] 2. A water tank, 12 ft in diameter, is made from steel plates that are 1/2 in. thick. [05] Determine the maximum height to which the tank may be filled if the circumferential stress is limited to 4000 psi. The specific weight of water is 62.4 lb/ft^3. [Consider both uniform and non-uniform distribution of pressure] [CO3, C4] Necessary Equations σx' = (σx + σy)/2 + (σx - σy)/2 cos 2θ + τxy sin 2θ τx'y' = -(σx - σy)/2 sin 2θ + τxy cos 2θ σy' = (σx + σy)/2 - (σx - σy)/2 cos 2θ - τxy sin 2θ tan 2θp = τxy / ((σx - σy)/2) σmax, min = (σx + σy)/2 +/- sqrt(((σx - σy)/2)^2 + (τxy)^2) tan 2θs = -((σx - σy)/2) / τxy τmax = sqrt(((σx - σy)/2)^2 + (τxy)^2)