Skip to content

Communication Engineering

EEE · Midterm · Summer 26

Paper 1 of 2Batch 242Switch

Batch 242

Paper 1 of 2

This browser can’t show the PDF here

Open it, and your phone’s PDF viewer takes it, or download it.

Read the questions as text

Read off the PDF by AI, so it may have mistakes. The PDF is the original.

Daffodil International University Department of Electrical and Electronic Engineering Faculty of Engineering Midterm Examination, Summer-2026 Course Code: 0714-311 Course Title: Communication Engineering Section: A,B,C,D,E Level-Term: L3-T1 Teacher's Initial: FHT, AB Full Marks: 25 Exam Date: July 4, 2026 Time: 1.5 Hours Answer all Questions [The second right most column indicates the course outcomes with respective Bloom's level and right most column indicates the allocated marks] Q1. (a) Describe a general communication system with a neat block diagram. Explain the function of each block in detail. CO-1 C(2) 3 (b) Discuss the major challenges faced in communication systems. CO-1 C(2) 2 Q2. (a) State Shannon's channel theorem in a noisy channel. CO-1 C(1) 1 (b) A receiver front-end consists of two cascaded amplifiers, amplifier 1 (A1) and Amplifier 2 (A2). The input signal power fed into the first stage is, 5uW and the accompanying input noise power from the source antenna is 40nW. CO-1 C(3) 2.5+2.5 Amplifier 1 is an ideal amplifier which is placed first with a power gain of 13dB and Amplifier 2 is a non-ideal amplifier with a power gain of 20dB and an internal noise power of 360 nW (referred to its own input). Determine the following (i) Input and Output SNR of each amplifier (ii) Noise factor and noise figure of each amplifier. Q3. A baseband message signal is given by m(t) = cos(omega_m t) and the radio-frequency carrier signal is given by c(t) = cos(omega_c t), where omega_c > omega_m CO-2 C(3) 3+3 (a) Using a multiplier modulator, derive the mathematical expression for the generated DSB-SC signal, s(t). Sketch the frequency spectrum of (i) original message signal, m(t). (ii) The generated DSB-SC signal, highlighting USB and LSB. (b) Further, using a coherent demodulator, derive the expression for the recovered signal and explain the demodulation process. Also sketch the frequency spectrum of (i) combined signal before it passes through the appropriate filter (ii) the final spectrum after filtering. Q4. Explain the working of a non-linear DSB-SC modulator operating as a single balanced modulator. Derive the output expression and illustrate the frequency spectrum of the generated DSB-SC wave with suitable diagrams. Also state why the modulator is referred to as a single balanced modulator. CO-2 C(3) 5 Q5. Sketch the AM signal [A+m(t)]cos(omega_c t) for the periodic triangular modulating signal m(t) shown in the Fig.1, corresponding to the following modulation indices: (i) mu = 0.5 (ii) mu = 1 CO-2 C(3) 3 [Figure: A triangular waveform m(t) oscillating between +10 and -10]