Embedded Systems and IoT
CSE · Final · Fall 24
Batch 62
Read the questions as text
Read off the PDF by AI, so it may have mistakes. The PDF is the original.
Daffodil International University
Faculty of Science & Information Technology
Department of Computer Science & Engineering
Final Semester Examination, Fall 2024
Course Code: CSE233, Course Title: Embedded Systems and IoT
Level: 3 Term: 2 Batch: 62
Time: 2:00 Hrs | Marks: 40
Answer ALL Questions
[The figures in the right margin indicate the full marks and corresponding course outcomes. All portions of each question must be answered sequentially.]
1. a) | Illustrate any wireless module used in an IoT system. | [2] | CO1
1. b) | Distinguish BJT and MOSFET with proper application. | [2] |
1. c) | Explain RISC and CISC with proper application. | [2] |
1. d) | Describe the interrupt controller in the microcontroller unit. | [2] |
1. e) | Recall the main differences between Von Neumann and Harvard architecture. | [2] |
2. a) | Differentiate STM32 microcontroller from 8051 unit in terms of interfacing sensors, actuators or other networks. | [4] | CO2
2. b) | Develop an embedded C program for an Automatic Pet Feeder using an Arduino and a servo motor. The servo must open a flap for 5 seconds to dispense food, then close it. Demonstrate understanding of system requirements through accurate implementation. | [5] |
3. a) | For a microcontroller-based project, which type of Flash memory would you prefer among PROM, EPROM, and EEPROM? Justify your choice based on the specific needs and requirements of the project. | [4] | CO3
3. b) | Demonstrate the process of developing a warehouse monitoring system that utilizes I2C to interface with sensors (such as temperature and humidity sensors) and SPI to control actuators (like fans and lights). Provide a comprehensive list of components required for the system and present a detailed design for implementation. | [5] |
4. a) | Construct a general block diagram of the Cortex-M processor core and explain the fundamental components of it. | [5] | CO4
4. b) | Design a smart city environmental monitoring system tailored for Daffodil Smart City using an STM32 microcontroller. The system should measure air quality, noise levels, and weather conditions. Implement LoRa WAN for long-range communication, Ethernet for high-speed data upload, and Bluetooth for on-site maintenance. Provide a detailed system schematic, block diagram with proper explanation. | [7] |