Embedded Systems and IoT
CSE · Midterm · Summer 25
Paper 1 of 2Batch 61 · Hafizur RahmanSwitch
Batch 61
Paper 1 of 2
Read the questions as text
Read off the PDF by AI, so it may have mistakes. The PDF is the original.
Daffodil International University
Faculty of Science & Information Technology
Department of Computer Science & Engineering
Midterm Examination, Summer 2025
Course Code: CSE233
Course Title: Embedded System and IoT
Level: 4
Term: 2
Batch: 61
Time: 1:30 Hrs
Full Marks: 25
Answer all the following Three questions
[All portions of each question must be answered sequentially]
Q1. a. The Arduino board provides 5V and 3.3V outputs. Explain their purpose using Ohm's Law. | 5x2=10 | CO1
b. Explain how placing a capacitor with a MOSFET can increase the delay in operation of embedded systems.
c. Why is a Zener diode often placed across the power input of an embedded device?
d. Explain how a transistor acts as a switch in embedded circuits such as LED blinking or motor control.
e. Illustrate the various components of a generalized microcontroller architecture using a block diagram.
Q2. a. Develop an Arduino-based automatic obstacle detection system to measure the distance using only a single sensor. Provide the full Arduino code along with a clearly labeled circuit diagram showing all connections. [Figure: HC-SR04] | 2x4=8 | CO2
b. Develop an Arduino-based system to control the operation of a DC motor using a regulated power supply. The system should allow the Arduino to control the DC motor through an H-bridge motor driver (such as L298N or L293D), enabling forward and reverse motion. Ensure that the DC motor draws regulated power supply from the Arduino board. Include a complete circuit diagram and Arduino code.
Q3. Design an Arduino-based automatic alarm system inspired by real-world military or defense applications, such as those potentially used in the recent Iran-Israel conflict. The prototype system should automatically open a door when a siren or buzzer sound is detected. Additionally, an LED should be used as a visual indicator to signal when the system has detected the alarm and triggered the door mechanism. Your answer should include the following sections: Problem Overview, System Requirements, Components Required, System Design with complete block diagram, Software Design and Conclusion. | 7 | CO3