Electronic Devices and Circuits
CSE · Final · Fall 24
Paper 2 of 2Batch AllSwitch
Batch All
Paper 2 of 2
Read the questions as text
Read off the PDF by AI, so it may have mistakes. The PDF is the original.
Daffodil International University
Department of Computer Science and Engineering
Faculty of Science & Information Technology
Final Examination, Fall 2024
Course Code: CSE215/224 Course Title: Electronic Devices and Circuits
Level: All Term: All Batch: All
Time: 2 Hours
Full Marks: 40
Answer all the following three questions
[All portions of each question must be answered sequentially]
Q1. | a. | Write a short note on depletion mode and enhancement mode operation of MOSFET. | 5x1 = 5 | CO1
Q1. | b. | Define Transistor Biasing.
Q1. | c. | Write a short note on an OP-AMP.
Q1. | d. | Define Bandwidth.
Q1. | e. | Why is an oscillator better than an alternator for frequency generation?
Q2. | a. | Compare among the BJT, FET and MOSFET. | 3x5 = 15 | CO2
Q2. | b. | Explain the principles of negative voltage feedback in amplifiers.
Q2. | c. | Explain the operation of the tank circuit in detail.
Q3. | a. | For a certain D-MOSFET, IDSS = 10 mA and VGS (off) = -8V.
(i) Is this an n-channel or a p-channel?
(ii) Calculate ID at VGS = - 3V.
(iii) Calculate ID at VGS = + 3V. | 4x5 = 20 | CO3
Q3. | b. | A Transistor is biased using Voltage Divider Biased Method, where R1 = 10 kΩ, R2 = 10 kΩ, RC = 1 kΩ, RE = 5 kΩ, VCC = 10V.
Solve to Find:
(i) Emitter Current of the circuit
(ii) Calculate VCE
(iii) also calculate Voltage at Collector terminals
Q3. | c. | When negative voltage feedback is applied to an amplifier of gain 1000, the overall gain falls to 50.
(i) Calculate the fraction of the output voltage feedback.
(ii) If this fraction is maintained, calculate the value of the amplifier gain required if the overall stage gain is to be 25.
Q3. | d. | Design an oscillator which can generate a frequency of 1 KHz, if the following information are available:
One inductor of 1000mH and feedback fraction, m_v = 0.1. Also draw the feedback circuit only.