Continuous Signals and Linear Systems
EEE · Final · Spring 26
Read the questions as text
Read off the PDF by AI, so it may have mistakes. The PDF is the original.
Daffodil International University
Department of Electrical and Electronic Engineering
Faculty of Engineering
Final Examination, Spring - 2026
Course Code: EEE-0714-217
Course Title: Continuous Signals & Linear Systems
Section: A, B, C, D
Level-Term: L2-T1
Teacher's Initial: MFI
Full Marks: 40
Exam Date: April 29, 2026
Time: 2 Hours
Answer all the following Questions
The second right most column indicates the course outcomes with respective Bloom's level and right most column indicates the allocated marks
Q1. Find the Laplace transform X(s) and sketch the pole-zero plot with the ROC for the signal x(t) = e^(2t)u(-t) + e^(-3t)u(t).
Q2. Consider the RC circuit shown in Fig. 1. The switch is closed at t = 0. Assume that there is an initial voltage on the capacitor and v_c(0^-) = v_0. Using the transform network technique, Find the current i(t) and the voltage across the capacitor v_c(t).
[Figure: RC circuit diagram with a voltage source V, a switch at t=0, a resistor R, and a capacitor C with current i(t) and voltage v_c(t)]
Q3. Consider the periodic square wave x(t) shown in Fig. 2. Determine the complex exponential Fourier series and the trigonometric Fourier series of x(t).
[Figure: Periodic square wave graph of x(t) versus t with pulses between -2T_0 to 2T_0]
Q4. Consider a continuous-time LTI system described by dy(t)/dt + 2y(t) = x(t) + dx(t)/dt. Using the Fourier transform, find the output y(t) to each of the input signals: (i) x(t) = e^(-t)u(t) (ii) x(t) = u(t).
Q5. Derive state variable matrices for the continuous time LTI system given in Fig. 3.
[Figure: Continuous time LTI system circuit diagram with resistors R_1, R_2, inductor L, capacitor C, input x(t), states q_1(t) and q_2(t), and output y(t)]
u(t) = { 1; t >= 1, 0; t < 1 }