Continuous Signals and Linear Systems
EEE · Final · Fall 25
Read the questions as text
Read off the PDF by AI, so it may have mistakes. The PDF is the original.
Daffodil International University
Department of Electrical and Electronic Engineering
Faculty of Engineering
Final Examination, Fall - 2025
Course Code: EEE-0714-217
Section: A, B, C, D, E
Full Marks: 40
Course Title: Continuous Signals & Linear Systems
Level-Term: L2-T1
Exam Date: December 24, 2025
Teacher's Initial: MFI
Time: 2 Hours
Answer all the following Questions
Q1. Find the Laplace transform X(s) and sketch the pole-zero plot with the ROC for the signal x(t) = e^(-2t)u(t) + e^(-3t)u(t).
Q2. Consider the RC circuit shown in Fig. 1. The switch is closed at t = 0. Assume that there is an initial voltage on the capacitor and v_c(0^-) = v_0. (i) Find the current i(t) and the voltage across the capacitor v_c(t).
[Figure: An RC circuit with a DC voltage source, a switch at t=0, a resistor R, and a capacitor C in parallel]
Q3. Consider the periodic square wave x(t) shown in Fig. 2. Determine the complex exponential Fourier series and the trigonometric Fourier series of x(t).
[Figure: A periodic square wave plot of x(t) versus t with pulses of amplitude 1 from -T_0/4 to T_0/4 and periodic intervals]
Q4. Consider a continuous-time LTI system described by dy(t)/dt + 2y(t) = x(t). Using the Fourier transform, find the output y(t) to each of the input signals: (i) x(t) = e^(-t)u(t) (ii) x(t) = u(t).
Q5. Derive state variable matrices for the continuous time LTI system given in Fig. 3.
[Figure: A continuous time LTI circuit diagram with two loops containing resistors R_1, R_2 and capacitors C_1, C_2]