Skip to content

Electronic Devices and Circuits

CSE · Midterm · Fall 25

Paper 2 of 3Batch 67 · Ahnab ShariarSwitch

Batch 67

Paper 2 of 3

This browser can’t show the PDF here

Open it, and your phone’s PDF viewer takes it, or download it.

Read the questions as text

Read off the PDF by AI, so it may have mistakes. The PDF is the original.

Daffodil International University Faculty of Science & Information Technology Department of Computer Science & Engineering Mid Term Examination, Fall 2025 Course Code: CSE215 | Course Title: Electronic Devices and Circuits Level: 2 | Term: 1 | Batch: 67 Time: 01:30 Hrs | Marks: 25 Answer ALL Questions [The figures in the right margin indicate the full marks and corresponding course outcomes. All portions of each question must be answered sequentially.] 1. a) Mention the types of transistor configurations used in circuits. | CO1 | 5x1=5 1. b) State the negative temperature coefficient of resistance property of semiconductors. 1. c) Recall the purpose of using a clipper circuit in waveform shaping. 1. d) List the advantages of silicon compared to germanium for making semiconductor devices. 1. e) Define Ripple Factor. 2. a) Explain with circuit and waveforms how a Full-wave bridge rectifier converts AC into pure DC. | CO2 | 4x2=8 2. b) Explain the working principle of NPN and PNP transistor in detail. 3. a) The two semiconductor diodes used in a rectifier circuit have forward resistance which can be considered constant at 0.1 ohm and infinite reverse resistance. They supply a mean current of 10 A to a resistive load from a sinusoidally varying alternating supply of 20 V (RMS). Solve for: i) The resistance of the load ii) The efficiency of the circuit | CO3 | 4x3=12 3. b) In the laboratory, you are provided with a 72 V DC power supply, 16 V Zener diodes, series resistors of 2 kilo ohm, and a load resistor of 4 kilo ohm. You are required to design a voltage stabilizer to provide a stable voltage of approximately 48 V for a sensitive device using only the available Zener diodes, resistors, and power supply. Also, Solve for (i) the output voltage (ii) the voltage drops across series resistance and (iii) the current through the Zener diode. 3. c) The transistor shown in figure 1 is of silicon and has beta = 150 Solve for: i. Base Current, IB. ii. Collector Current, IC iii. Collector-Emitter Voltage, VCE. [Figure: Circuit diagram showing an NPN transistor with base resistor RB = 10 kilo ohm connected to VBB = 5V, collector resistor RC = 100 ohm connected to VCC = 10V, and emitter connected to ground.] Good Luck!