Electronic Devices and Circuits
CSE · Midterm · Summer 26
Paper 2 of 3Batch 68 · Nipun Prakash PramanikSwitch
Batch 68
Paper 2 of 3
Read the questions as text
Read off the PDF by AI, so it may have mistakes. The PDF is the original.
Daffodil International University
Faculty of Science & Information Technology
Department of Computer Science & Engineering
Midterm Examination, Summer 2026
Course Code: CSE215, Course Title: Electronic Devices and Circuits
Level: 2 Term: 2 Batch: 68
Time: 01:30 Hrs
Marks: 25
Answer ALL Questions
[The figures in the right margin indicate the full marks and corresponding course outcomes. All portions of each question must be answered sequentially.]
1. a) Define Ripple Factor. | [1] | CO1
1. b) Why is silicon preferred over germanium in modern semiconductor devices? | [1] |
1. c) What do you mean by Peak Inverse Voltage? | [1] |
1. d) What is hole current in semiconductor? | [1] |
1. e) Define Knee voltage. | [1] |
2. a) Explain the biasing of a PN junction with proper diagram. | [4] | CO2
2. b) Show that in half-wave rectification, a maximum of 40.6% of a.c. power is converted into d.c. power. | [4] |
3. a) A transistor is connected in common emitter (CE) configuration in which collector supply is 10V and the voltage drop across resistance Rc, connected in the collector circuit is 0.6V. The value of Rc = 900 ohms. If alpha = 0.94,
Solve for:
i) Collector-emitter voltage
ii) Base current | [4] | CO3
3. b) A voltage regulator circuit uses two zener diodes, each rated at 10 V and 250 mA, as shown in Fig. 01. If the circuit is connected to a 45 V unregulated supply and load resistance is 1k ohm, solve for:
i) The regulated output voltage across RL
ii) The value of series resistance R
[Figure: A circuit diagram showing a 45V DC source connected via series resistor R to a parallel combination of two Zener diodes Z1 and Z2 and a load resistor RL.] | [4] |
3. c) The transistor shown in Fig. 02 is of silicon and has beta = 100.
Solve for:
i) Base current
ii) Collector current and
iii) Collector-Emitter Voltage
[Figure: A transistor biasing circuit with VBB = 10V, RB = 1 mega-ohm, VCC = 20V, and RC = 10 kilo-ohm.] | [4] | CO3