Skip to content

Electronics I

EEE · Midterm · Fall 25

This browser can’t show the PDF here

Open it, and your phone’s PDF viewer takes it, or download it.

Read the questions as text

Read off the PDF by AI, so it may have mistakes. The PDF is the original.

Daffodil International University Department of Electrical and Electronic Engineering Faculty of Engineering Mid-Term Examination, Fall - 2025 Course Code: 0714-211 Course Title: Electronics I Teacher's Initial: SD Section: A, B, C, D, E Level-Term: L2-T1 Time: 1.5 Hours Marks: 25 Exam Date: October 20, 2025 [There are five (05) questions, answer all of them.] [The figures in the right-hand margin indicate the allocated marks.] [COs represent learning outcomes of the course.] Q1. Describe the working principle of an n channel JFET with necessary diagrams. Or Explain the operation and applications of Light Emitting Diode (LED). [CO-2, C(2)] [5] Q2. Describe the operation of a Center Tapped Transformer [turns ratio 1:2] Full Wave Rectifier with necessary diagrams. If the input to a center tapped transformer full wave rectifier made with Ge diode is 24 sin 80t V, find the PIV of the diodes used in the rectifier. [CO-2, C(2)] [5] Q3. Determine ID1, ID2 and Vo for the following circuit in Fig. Q3. [CO-2, C(3)] [5] [Figure: A bridge rectifier circuit with a +20V supply, a Si diode (ID1) on the top branch, a GaAs diode (ID2) on the bottom branch, connected to a load network with 2 kOhm resistors as shown in Fig. Q3] Q4. Determine and sketch the output signal of the following clipper circuit in Fig. Q4 for the given input signal. [CO-2, C(3)] [5] [Figure: A clipper circuit with a sinusoidal input signal varying between +8 V and -8 V, a 1 kOhm series resistor, a Si diode pointing downwards in parallel, and a 4 V DC voltage source in series with the diode as shown in Fig. Q4] Q5. For the following circuit in Fig. Q5, determine: (i) The minimum value of RL to ensure that the Zener Diode is in the "on" state. (ii) The value of RL that will establish maximum power conditions for the Zener diode. (iii) The range of IL when VL is being maintained at 12V. [CO-2, C(3)] [5] [Figure: A Zener diode voltage regulator circuit with a 20 V DC source, a series resistor RS = 220 Ohm, a Zener diode with Vz = 12 V and Pz_max = 400 mW, and a load resistor RL carrying load current IL in parallel with the Zener diode as shown in Fig. Q5]