Skip to content

Electrical Circuits I

EEE · Final · Fall 25

This browser can’t show the PDF here

Open it, and your phone’s PDF viewer takes it, or download it.

Read the questions as text

Read off the PDF by AI, so it may have mistakes. The PDF is the original.

Daffodil International University Department of Electrical and Electronic Engineering Faculty of Engineering Final Examination, Fall - 2025 Course Code: 0713-111 Course Title: Electrical Circuit I Section: A, B, C, D, E, F, G, H Level-Term: L1-T1 Teacher's Initial: MRK, FHT Full Marks: 40 Exam Date: December 17, 2025 Time: 2 Hours [Answer all questions. Figures in the right margin indicates full marks.] Q1. (a) State superposition theorem. Use superposition to find Vx in the circuit of Fig. 1. CO2 [6] CO3 [Figure: Circuit diagram showing a 20V voltage source in series with a 20 ohm resistor, a 4A current source, a 4 ohm resistor, and a dependent current source 0.1Vx across Vx.] Fig. 1 (b) Find io in the circuit of Fig. 2 using source transformation. CO2 [4] CO3 [Figure: Circuit diagram with 6 ohm, 5A source, 3 ohm, 5V, io, 7 ohm, 1 ohm, 3A source, and 4 ohm resistors.] Fig. 2 Q2. (a) State and prove the Maximum Power Transfer Theorem for a DC circuit. CO2 [5] CO2 (b) Determine the value of resistor connected across terminals a-b which will absorb maximum power from the circuit shown in Fig. 3. Determine that power. CO2 [5] CO3 [Figure: Circuit diagram with 5A source, 4 ohm resistor, 2V source, 2 ohm resistor, 2 ohm resistor, 6 ohm resistor, and terminals a-b.] Fig. 3 Q3. (a) Explain the transient charging behavior of a capacitor in an RC network, and sketch the corresponding voltage and current waveforms. CO3 [4] CO4 (b) [Figure: Circuit diagram with E=10V, R1=80 k-ohm, switch positions 1, 2, 3, C=0.05 uF, R2=160 k-ohm.] Fig. 4 i) Find the mathematical expression for the transient behavior of the voltage across the capacitor and current through the capacitor of Fig. 4 if the switch is thrown into position 1 at t = 0 s. ii) Find the mathematical expressions for the response of vc and ic if the switch is thrown into position 2 at 32 ms (assuming that the leakage resistance of the capacitor is infinite ohms). iii) Find the mathematical expressions for the voltage vc and current ic if the switch is thrown into position 3 at t = 52 ms. iv) Plot the waveforms obtained in parts (i) through (iii) on the same time axis for the voltage vc and the current ic using the defined polarity and current direction of Fig. 4. Q4. (a) Determine Vc, Ic and the energy stored in the capacitor and inductor in the circuit of Fig. 5 under dc conditions. CO3 [4] [Figure: Circuit diagram with 4A source, 6 ohm resistor, 6H inductor, 2 ohm resistor, 4F capacitor, vc and ic.] Fig. 5 (b) Define the terms permeability and magnetizing force as used in magnetic circuits. [2] (c) Determine the secondary current I2 for the transformer of Fig. 6 if the resultant clockwise flux in the core is 0.2 x 10^-5 Wb. [4] [Figure: Magnetic core transformer with I1=2A, N1=60 turns, sheet steel, N2=30 turns, I2, dimensions labcda = 0.16m, Area = 0.15 x 10^-3 m^2.] Fig. 6