Skip to content

Data Communication and Computer Networking

SWE · Final · Fall 25

This browser can’t show the PDF here

Open it, and your phone’s PDF viewer takes it, or download it.

Read the questions as text

Read off the PDF by AI, so it may have mistakes. The PDF is the original.

Daffodil International University Faculty of Science & Information Technology Department of Software Engineering Final Examination, Fall 2025 Course Code: SE-225 Course Title: Data Communication & Computer Networking Sections & Teachers: AMR(A,B), KBB(C,D), FT(E,F), FC(G,H), MNA(I), RT(J,L), NBA(K), MSP(M,N) Time: 2:00 Hrs Marks: 40 Answer ALL Questions [The figures in the right margin indicate the full marks and corresponding course outcomes. All portions of each question must be answered sequentially.] 1. a) Examine the differences between TCP and UDP with respect to reliability, connection type, and common use cases. [Marks-2] | CLO-1 Level-3 1. b) Illustrate the HTTP request-response cycle. [Marks-3] 2. You are working on an upgraded file transmission system where data is transmitted in 6-bit chunks. As before, the system uses Hamming Distance to evaluate error detection/correction capability and Cyclic Redundancy Check (CRC) for error detection over the concatenated data. The file is divided into the following 6-bit data chunks: - Chunk 1: 101011 - Chunk 2: 110010 - Chunk 3: 011001 - Chunk 4: 111100 2. a) Apply your knowledge on Hamming Distance to calculate: - The maximum number of bit errors that can always be detected by a block code - The maximum number of bit errors that can be corrected by such a code. [Marks-4] | CLO-3 Level-3 2. b) Derive the CRC generator polynomial (in binary) according to: x^2 + 1 [Marks-1] 2. c) The data to be transmitted is formed by binary addition of Chunk 1 & Chunk 4. Data = Chunk 1 + Chunk 4 Using the generator polynomial obtained in part (b), Calculate the CRC bits for this data. [Marks-5] 3. You are designing an IPv4 addressing plan for a medium-sized office network. Your ISP has allocated the address block: 11000000.10101000.00101000.00000000/26 This block will be used to create multiple subnets for different departments. 3. a) Transform the given IP address into its decimal representation. [Marks-2] | CLO-4 Level-4 3. b) Identify the appropriate subnet mask. [Marks-3] 3. c) Examine each subnet and identify the network ID, broadcast IP, and range of usable host IP addresses for every subnet. [Marks-8] 3. d) Investigate whether 192.168.40.70 is a valid host IP address; if it is valid, identify the subnet to which it belongs. [Marks-2] 3. e) Analyze the purpose of CIDR (Classless Inter-Domain Routing) in IPv4 networking, focusing on how it helps conserve address space and reduce routing table size. [Marks-3] 4. A Weighted Network Graph is given below: [Figure: A weighted network graph with nodes A, B, C, D, E connected by edges with weights: A-B=5, A-D=8, B-D=3, B-C=12, B-E=7, D-E=4, C-E=10] 4. a) Identify the initial routing table for each node in the network. Trace the Distance Vector algorithm to figure out the updated routing tables for Node C and Node E. [Marks-7] | CLO-4 Level-4