Data Communication and Computer Networking
SWE · Final · Fall 25
Read the questions as text
Read off the PDF by AI, so it may have mistakes. The PDF is the original.
Daffodil International University
Faculty of Science & Information Technology
Department of Software Engineering
Final Examination, Fall 2025
Course Code: SE-225
Course Title: Data Communication & Computer Networking
Sections & Teachers: AMR(A,B), KBB(C,D), FT(E,F), FC(G,H), MNA(I), RT(J,L),
NBA(K), MSP(M,N)
Time: 2:00 Hrs
Marks: 40
Answer ALL Questions
[The figures in the right margin indicate the full marks and corresponding course
outcomes. All portions of each question must be answered sequentially.]
1. a) Examine the differences between TCP and UDP with respect to
reliability, connection type, and common use cases.
[Marks-2] | CLO-1
Level-3
1. b) Illustrate the HTTP request-response cycle.
[Marks-3]
2. You are working on an upgraded file transmission system where data is transmitted in 6-bit
chunks. As before, the system uses Hamming Distance to evaluate error detection/correction
capability and Cyclic Redundancy Check (CRC) for error detection over the concatenated
data.
The file is divided into the following 6-bit data chunks:
- Chunk 1: 101011
- Chunk 2: 110010
- Chunk 3: 011001
- Chunk 4: 111100
2. a) Apply your knowledge on Hamming Distance to calculate:
- The maximum number of bit errors that can always be detected
by a block code
- The maximum number of bit errors that can be corrected by such
a code.
[Marks-4] | CLO-3
Level-3
2. b) Derive the CRC generator polynomial (in binary) according to:
x^2 + 1
[Marks-1]
2. c) The data to be transmitted is formed by binary addition of Chunk 1 &
Chunk 4.
Data = Chunk 1 + Chunk 4
Using the generator polynomial obtained in part (b), Calculate the CRC
bits for this data.
[Marks-5]
3. You are designing an IPv4 addressing plan for a medium-sized office network.
Your ISP has allocated the address block:
11000000.10101000.00101000.00000000/26
This block will be used to create multiple subnets for different departments.
3. a) Transform the given IP address into its decimal representation.
[Marks-2] | CLO-4
Level-4
3. b) Identify the appropriate subnet mask.
[Marks-3]
3. c) Examine each subnet and identify the network ID, broadcast IP, and
range of usable host IP addresses for every subnet.
[Marks-8]
3. d) Investigate whether 192.168.40.70 is a valid host IP address; if it is
valid, identify the subnet to which it belongs.
[Marks-2]
3. e) Analyze the purpose of CIDR (Classless Inter-Domain Routing) in IPv4
networking, focusing on how it helps conserve address space and reduce
routing table size.
[Marks-3]
4. A Weighted Network Graph is given below:
[Figure: A weighted network graph with nodes A, B, C, D, E connected by edges with weights: A-B=5, A-D=8, B-D=3, B-C=12, B-E=7, D-E=4, C-E=10]
4. a) Identify the initial routing table for each node in the network. Trace the
Distance Vector algorithm to figure out the updated routing tables for
Node C and Node E.
[Marks-7] | CLO-4
Level-4