Skip to content

Transmission and Distribution of Electrical Power

EEE · Final · Summer 26

This browser can’t show the PDF here

Open it, and your phone’s PDF viewer takes it, or download it.

Read the questions as text

Read off the PDF by AI, so it may have mistakes. The PDF is the original.

Daffodil International University Department of Electrical and Electronic Engineering Faculty of Engineering Final Examination, Summer-2026 Course Code: 0713-227 Course Title: Transmission and Distribution of Electrical Power Section: A, B, C, D, E Level-Term: L3-T1 Teacher's Initial: SHS, SMP, AJA Full Marks: 40 Exam Date: August 24, 2026 Time: 2 Hours There are 5 questions. Answer all of them. COs on the right side indicate course learning outcomes Q1. (a) Explain the advantage of 3-wire DC distribution system over 2-wire DC distribution system. CO-1, C(2), 4+4 (b) Discuss the basic differences between overhead and underground transmission systems. CO-2 Q2. The self capacitance of each unit in a string of three suspension insulators is C. The shunting capacitance of the connecting metal work of each insulator to earth is 0.15 C while for line it is 0.1 C. Calculate (i) the voltage across each insulator as a percentage of the line voltage to earth and (ii) string efficiency. CO-3, C(3), 6+2 Q3. (a) A 2-wire d.c. distributor AB is fed from both ends. At feeding point A, the voltage is maintained at 230 V and at B 235 V. The total length of the distributor is 200 meters and loads are tapped off as under: 25 A at 50 meters from A; 50 A at 75 meters from A; 30 A at 100 meters from A; 40 A at 150 meters from A. The total resistance per kilometer of the distributor line is 0.3 ohm. Calculate: (i) currents in various sections of the distributor (ii) minimum voltage and the point at which it occurs. CO-2, C(4), 5+3 (b) A 250 m, 2-wire d.c. distributor fed from one end is loaded uniformly at the rate of 1.6 A/meter. The resistance of each conductor is 0.0002 ohm per meter. Calculate the voltage necessary at feed point to maintain 250 V (i) at the far end (ii) at the mid-point of the distributor. Q4. A 3-phase, 50 Hz, 400 V motor develops 100 H.P. (74.6 kW) at power factor of 0.75 lagging. The motor efficiency is 93%. A bank of capacitors is connected in delta across the supply terminals and power factor raised to 0.95 lagging. Each of the capacitance units is built of 4 similar 100 V capacitors. Determine the capacitance of each capacitor. CO-3, C(3), 8 Q5. (a) Write short notes on any two of the following: (i) Smart Grid, (ii) HVDC, (iii) SCADA. CO-1, C(2), 4+4 (b) Discuss the different ways of insulator failure.