Transmission and Distribution of Electrical Power
EEE · Midterm · Fall 25
Section A, B and C
Read the questions as text
Read off the PDF by AI, so it may have mistakes. The PDF is the original.
Daffodil International University
Department of Electrical and Electronic Engineering
Faculty of Engineering
Mid Term Examination, Fall-2025
Course Code: 0713-227
Course Title: Transmission and Distribution of Electrical Power
Section: A, B & C
Level-Term: L2-T2
Teacher's Initial: KA
Full Marks: 25
Exam Date: October 18, 2025
Time: 1.5 Hours
[There are three (3) questions, answer all of them.]
[The figures in the right-hand margin indicate the allocated marks.]
[COs represent learning outcomes of the course.]
Q1. a) Explain why A.C.S.R. conductors the ideal choice for distribution and transmission lines. CO1 C-2 02
b) Compare DC and AC voltage transmission based on their advantages and disadvantages. CO1 C-2 03
c) Define skin effect and corona? Discuss the methods for reducing corona effect in an overhead transmission line. CO1 C-2 03
d) Identify the main advantages of suspension type insulator over pin type insulator. List the methods for improving string efficiency? CO1 C-2 04
Q2. a) Show that in a string of suspension insulators, the disc nearest to the conductor has the highest voltage across it. CO2 C-2 03
b) The three bus-bar conductors are being supported by three-disc insulators having a safe working voltage of 2A.C kV. The voltage across the across the top unit is 1B.C kV. Calculate
i) The bus-bar voltage
ii) String efficiency
Here, ABC is last 3 digit of your Student ID. CO2 C-4 03
c) A three-phase transmission line 120 km long, is delivering 20 MW at 66 kV 0.85 power factor lagging has the following constants:
Resistance/km = 0.03 Omega
Reactance/km = 0.065 Omega
Susceptance/km = 0.06 x 10^-6 siemens
Estimate (i) The voltage regulation (ii) The transmission efficiency, considering the total capacitance of the line is localized at the receiving end alone. CO2 C-4 04
Q3. a) A transmission line has a span of 250 m between level supports. The conductor has a cross-sectional area of 3.80 cm^2. The breaking stress of the conductor is 4218 kg/cm^2. The specific gravity of the conductor material is 2.7 gm/cm^3 and wind pressure is 1.2 kg/m length. Determine the height of the conductor above the ground level at which it should be supported if a minimum clearance of 6.5 m is to be left between the ground and the conductor and safety factor is 3. CO3 C-3 03