Basic Electrical and Electronic Engineering
TE · Midterm · Spring 26
Paper 1 of 2By Shafiur Rahman Shafim (242)Switch
Paper 1 of 2
Read the questions as text
Read off the PDF by AI, so it may have mistakes. The PDF is the original.
Daffodil International University
Department of Textile Engineering (TE)
Faculty of Engineering
Mid Examination, Spring-2026
Course Code: 0713-221
Course Title: Basic Electrical and Electronic Engineering
Level & Term: L2T2
Full Marks: 25, Time: 1.5 hours
(Ans any 5 set of Questions)
1. a. Explain passive sign convention with appropriate diagram. [CLO-2, C2, C3] [2+3]
b. Calculate the equivalent resistance of the circuit:
[Figure: A complex resistor network with a 54 V DC voltage source at the bottom left, connected to series-parallel resistors R1 through R14 with various resistance values from 2 ohms to 9 ohms.]
2. a. Determine the total charge entering a terminal in between t=1s to t=5s ; if current, i = (10t^4 -3t^2) A [CLO-2, C5, C5, C2] [2+2+1]
b. Determine the total current entering a terminal at t 0.2s; if total charge, q = 15t^2sin4rt mC
c. Explain why it is said that 'Electric current is always through an element and electric voltage is always across the element'
3. a. State the law of conversion of energy. [CLO-2, C2, C3] [1+4]
b. From the following circuit prove that it obeys the law of conversion of energy.
[Figure: A circuit diagram with a 12 V voltage source, a 20 V voltage source, 6 A current source, 8 V voltage source, and a dependent current source 0.2I across terminals P1, P2, P3, P4.]
4. a. Discuss different types of dependent sources with proper symbols. [CLO-1, C2, C3] [2+3]
b. Convert the delta network to an equivalent ywe network [CLO-2, C1, C2]
[Figure: A delta connected resistor network with nodes a, b, c, having resistances R1 = 60 ohm, R2 = 30 ohm, and R3 = 10 ohm.]
5. At a node, five currents meet: [CLO-2, C1, C2] [2+3]
i1 = 2x (entering)
i2 = x + 5 (leaving)
i3 = 6 (entering)
i4 = x + 7 (leaving)
i5 = 6 (direction unknown)
a. Determine the direction of i5 (entering or leaving) with reasoning.
b. "KCL was useless in this problem because it could not find x." Write a precise counter-argument - what specific and valuable information did KCL actually provide in this problem?
6. A closed loop contains only these elements: [CLO-2, C3, C2] [2+3]
V = 60 V (single voltage source, rising)
R1 = 3x + 2 (voltage drop)
R2 = 2x - 1 (voltage drop)
R3 = x + 5 (voltage drop)
R4 = 4x - 3 (voltage drop)
Loop current i = 3 A
a. Calculate the voltage drop across each resistor.
b. Suppose the polarity of R4 is reversed in the loop. Will the loop current still be 3A? Explain using KVL.