Skip to content

Basic Electrical and Electronic Engineering

TE · Midterm · Spring 26

Paper 2 of 2By Ahnab ShariarSwitch

Paper 2 of 2

This browser can’t show the PDF here

Open it, and your phone’s PDF viewer takes it, or download it.

Read the questions as text

Read off the PDF by AI, so it may have mistakes. The PDF is the original.

Daffodil International University Department of Textile Engineering (TE) Faculty of Engineering Mid Examination, Spring-2026 Course Code: 0713-221 | Course Title: Basic Electrical and Electronic Engineering Level & Term: L2T2 | Full Marks: 25, Time: 1.5 hours (Ans any 5 set of Questions) 1. a. Explain passive sign convention with appropriate diagram. [CLO-2, [2+3] b. Calculate the equivalent resistance of the circuit: C2,C3] [Figure: A complex DC resistive circuit with a 54 V battery and resistors R1 to R14 connected in a bridge and series-parallel combination.] 2. a. Determine the total charge entering a terminal in between t=1s to t=5s ; if current, i = (10t^4 - 3t^2) A [CLO-2, C5,C5, [2+2+1] b. Determine the total current entering a terminal at t 0.2s; if total charge, q = 15t^2 sin 4pi t mC C2] c. Explain why it is said that 'Electric current is always through an element and electric voltage is always across the element' 3. a. State the law of conversion of energy. [CLO-2, C2, C3] [1+4] b. From the following circuit prove that it obeys the law of conversion of energy. [Figure: A circuit diagram with a 20V source, 12V source, 8V source, a 0.2I dependent source, and nodes P1, P2, P3, P4.] 4. a. Discuss different types of dependent sources with proper symbols. [CLO-1, C1, C2] [2+3] b. Convert the delta network to an equivalent ywe network [Figure: A delta resistance network with nodes a, b, c and resistors R1 = 60 ohm, R2 = 30 ohm, R3 = 10 ohm.] 5. At a node, five currents meet: [CLO-2, C1,C2] [2+3] i1 = 2x (entering) i2 = x + 5 (leaving) i3 = 6 (entering) i4 = x + 7 (leaving) i5 = 6 (direction unknown) a. Determine the direction of i5 (entering or leaving) with reasoning. b. "KCL was useless in this problem because it could not find x." Write a precise counter-argument - what specific and valuable information did KCL actually provide in this problem? 6. A closed loop contains only these elements: [CLO-2, C3,C2] [2+3] V = 60 V (single voltage source, rising) R1 = 3x + 2 (voltage drop) R2 = 2x - 1 (voltage drop) R3 = x + 5 (voltage drop) R4 = 4x - 3 (voltage drop) Loop current i = 3 A a. Calculate the voltage drop across each resistor. b. Suppose the polarity of R4 is reversed in the loop. Will the loop current still be 3A? Explain using KVL.