Materials and Manufacturing Engineering
TE · Midterm · Spring 26
Paper 1 of 3Section F1, F2, F3 · Ahnab Shariar (1)Switch
Section F1, F2, F3
Paper 1 of 3
Read the questions as text
Read off the PDF by AI, so it may have mistakes. The PDF is the original.
Form Number: OBE/TE/Spring-2026
Daffodil International University
Department of Textile Engineering
Faculty of Engineering
Midterm Examination; Spring-2026
Course Code: 0722-221
Course Title: Materials and Manufacturing Engineering
Level & Term: L3T1
Section: F1, F2, F3
Name & Designation of the Course Teacher: Dr. Md. Abdul Gafur (MAG) and Professor
Time: 1.5 hours.
Total Marks: 25
Answer all the questions:
1. Analyze by finding i) ferrite and cementite, ii) ferrite and pearlite and iii) eutectoid ferrite, and also providing the microstructure for a 0.30%C steel temperature, just below eutectoid temperature. [CLO3, PO1, C4] (8)
2. Examine the microstructure by estimating %C and tensile strength for steel (hypoeutectoid steel) having 70% ferrite-pearlite microstructure in annealed condition at room temperature. The steel must be in annealed condition-why? [CLO3, PO1, C4] (8)
3. Distinguish between Annealing and Normalizing. [CLO3, PO1, C4] (4)
4. Analyze the microstructure that will be developed if cooling rate is slower than 140°C/S and faster than 35°C/S by defining critical cooling rate (CCR).[CLO3, PO1, C4] (5)
[Figure: Time-Temperature-Transformation (TTT) diagram showing cooling curves for 140°C/s, critical cooling rate, and 35°C/s, with phases like Austenite, Pearlite, and Martensite]