Skip to content

Materials and Manufacturing Engineering

TE · Midterm · Spring 26

Paper 1 of 3Section F1, F2, F3 · Ahnab Shariar (1)Switch

Section F1, F2, F3

Paper 1 of 3

This browser can’t show the PDF here

Open it, and your phone’s PDF viewer takes it, or download it.

Read the questions as text

Read off the PDF by AI, so it may have mistakes. The PDF is the original.

Form Number: OBE/TE/Spring-2026 Daffodil International University Department of Textile Engineering Faculty of Engineering Midterm Examination; Spring-2026 Course Code: 0722-221 Course Title: Materials and Manufacturing Engineering Level & Term: L3T1 Section: F1, F2, F3 Name & Designation of the Course Teacher: Dr. Md. Abdul Gafur (MAG) and Professor Time: 1.5 hours. Total Marks: 25 Answer all the questions: 1. Analyze by finding i) ferrite and cementite, ii) ferrite and pearlite and iii) eutectoid ferrite, and also providing the microstructure for a 0.30%C steel temperature, just below eutectoid temperature. [CLO3, PO1, C4] (8) 2. Examine the microstructure by estimating %C and tensile strength for steel (hypoeutectoid steel) having 70% ferrite-pearlite microstructure in annealed condition at room temperature. The steel must be in annealed condition-why? [CLO3, PO1, C4] (8) 3. Distinguish between Annealing and Normalizing. [CLO3, PO1, C4] (4) 4. Analyze the microstructure that will be developed if cooling rate is slower than 140°C/S and faster than 35°C/S by defining critical cooling rate (CCR).[CLO3, PO1, C4] (5) [Figure: Time-Temperature-Transformation (TTT) diagram showing cooling curves for 140°C/s, critical cooling rate, and 35°C/s, with phases like Austenite, Pearlite, and Martensite]