Skip to content

Basic Mechanical Engineering

EEE · Final · Fall 25

This browser can’t show the PDF here

Open it, and your phone’s PDF viewer takes it, or download it.

Read the questions as text

Read off the PDF by AI, so it may have mistakes. The PDF is the original.

Daffodil International University Department of Electrical and Electronic Engineering Faculty of Engineering Final Examination, Fall - 2025 Course Code: 0715-121 Course Title: Basic Mechanical Engineering Section: A, B, C, D, E, F Level-Term: L1-T2 Teacher's Initial: RT Full Marks: 40 Exam Date: December 20, 2025 Time: 2 Hours [Notes: All questions are compulsory] Q1. (a) Differentiate the benefits and drawbacks of window type and split type air conditioning system with the help of schematic diagram. CO-3 (C4) [6] (b) On a certain day, the dry and wet bulb temperatures are measured 35 C and 25 C respectively. Using Psychrometric Chart, Determine: CO-3 (C2) [4] i. The relative humidity ii. The humidity ratio iii. The dew point temperature of air Q2. (a) Compare 4 stroke SI & CI engine with the help of (i) The Actual Indicator Diagram and (ii) TS Diagram. CO-1 (C2) [6] (b) A six cylinder two stroke engine with a compression ratio r = 10 produces a torque of 1200 Nm at a speed of 1500 rpm. It has a bore (d) of 150 mm and stroke (L) of 180mm. Determine: CO-1 (C2) [4] i. The displacement volume and clearance volume of one cylinder ii. The engine brake work (Power), and mean piston speed Q3. (a) Discuss the working principle of an engine cooling system with a schematic diagram. CO-1 (C1) [4] (b) In a Diesel cycle, Compression begins at 0.15 MPa, 35 C. The heat added is 1.95 MJ/kg and the compression ratio is 18. Determine: CO-1 (C2) [6] i. The maximum temperature in the cycle ii. Work done per kg of air iii. The cycle efficiency iv. The temperature at the end of the isentropic expansion v. The cut-off ratio vi. The MEP of the cycle (Cp and Cv of air are 1.005 and 0.718 kJ/kg.K respectively, and the Gas Constant of air, R = 287 J/kg.K) Q4. (a) Draw (i) the schematic diagram, and (ii) T-S diagram of an ideal vapor compression refrigeration system with proper identification and thermodynamic processes. CO-3 (C2) [6] (b) A simple vapor compression refrigeration cycle uses refrigerant-134a as the working fluid and operates between 0.2MPa and 1.2 MPa. If the mass flow rate of the refrigerant is 0.06 kg/s, Compute: CO-3 (C3) [4] i. The rate of heat removal from the refrigerated space ii. The power input to the compressor iii. The rate of heat rejection to the environment, and iv. The COP of the refrigerant [Figure: ASHRAE Psychrometric Chart No. 1]