Skip to content

Basic Mechanical Engineering

EEE · Midterm · Fall 24

Section A, B, C

This browser can’t show the PDF here

Open it, and your phone’s PDF viewer takes it, or download it.

Read the questions as text

Read off the PDF by AI, so it may have mistakes. The PDF is the original.

Daffodil International University Department of Electrical and Electronic Engineering Faculty of Engineering Mid-Term Examination, Fall - 2024 Course Code: 0715-121 Course Title: Basic Mechanical Engineering Section: A, B, C Level-Term: L1-T2 Teacher's Initial: SS Full Marks: 25 Exam Date: October 5, 2024 Time: 1.5 Hours Notes: Question No. 1 is Compulsory Answer any Three from the rest of the Four Questions Q1. Define the following terms: (Any four) (a) HHV (b) Compounding of Steam Turbine (c) Fuel (d) Boiler Accessories (e) Superheated Steam Q2. (a) Illustrate the characteristics of a good fuel. Give a few examples of good fuels. (b) A fuel has the following composition by mass: Carbon 88%, Hydrogen 7.5%, Oxygen 2.75%, Sulfur 1.75%. For the complete combustion of 1 kg of fuel, Determine: i) The mass of the air to be supplied. ii) The mass of flue gas emitted. iii) The mass of total air to be supplied if 50% excess air is to be provided. Q3. (a) Describe the reasons why Economizers are used in boilers. Identify if they are Mountings or Accessories. Analyze how they increase boiler efficiency. (b) Solve these problems by showing proper chemical reactions. i) Ethanol (CH3CH2OH) has an HHV of 29.67 MJ/kg. Determine the LHV. (Specific latent heat of vaporization is 2.445 MJ/kg for water at 298 K) ii) What should be the difference between LHV and HHV for burning pure diamond (C)? Q4. (a) Explain the Boiling Process of water with proper graphical descriptions. (b) Illustrate the impracticalities of using the Carnot Cycle in a steam power plant. Describe how the Ideal Rankine Cycle overcomes these impracticalities with proper diagrams. Q5. (a) Describe how impulse turbines work. Differentiate impulse and reaction turbines in terms of blade and rotor shapes. (b) Identify the type of compounding shown in the following figure. Describe the compounding process. Also, construct the pressure-velocity diagram for this compounding. [Figure: diagram showing multiple stages of nozzles and moving blades, labeled M = Moving Blade and N = Nozzle]