Skip to content

Basic Mechanical Engineering

EEE · Final · Fall 24

Section A, B, C

This browser can’t show the PDF here

Open it, and your phone’s PDF viewer takes it, or download it.

Read the questions as text

Read off the PDF by AI, so it may have mistakes. The PDF is the original.

Daffodil International University Department of Electrical and Electronic Engineering Faculty of Engineering Final Examination, Fall - 2024 Course Code: 0715-121 Course Title: Basic Mechanical Engineering Section: A, B, C Level-Term: L1-T2 Teacher's Initial: SS Full Marks: 40 Exam Date: December 30, 2024 Time: 2 Hours Notes: All of the questions are Compulsory Q1. (a) i. Compare the Parallel and Series combinations of centrifugal pumps with their mathematical expressions. [1+2] (C1) ii. Define Cavitation. Mention some of its negative effects on pumps. Or, Define Priming. Explain why this is necessary for the operation of centrifugal pumps. (b) The inner and outer diameters of the impeller of a centrifugal pump are 300 mm and 600 mm respectively. The constant velocity of flow is 2.5 m/s and the vanes are curved backward at an angle of 35 degrees at the exit. If the manometric efficiency is 70%, Determine the Minimum Starting Speed of the pump. [5] (C3) Q2. (a) i. Define Valve Overlap. [2] (C3) ii. Differentiate briefly between Turbocharging and Supercharging. (C2) (b) Draw (i) the Actual Indicator Diagram and (ii) the Valve Timing Diagram of a 4-stroke SI Engine with proper identifications. Show the valve overlap position on the Valve Timing Diagram. [6] (C4) With the help of the diagrams, Illustrate the working principle of a 4-stroke SI Engine. Q3. (a) Describe (any of the two) the working principle of: [4] (C2) (i) Centrifugal Pump Or, (ii) Reciprocating Pump (b) A four-cylinder two-stroke engine with a compression ratio r = 8 produces a torque of 1200 Nm at a speed of 2500 rpm. It has a square cylinder with a bore of 125 mm. [4] (C3) Determine: i. The displacement volume and the clearance volume of one cylinder. ii. The engine brake work, and mean piston speed. Q4. (a) We know that theoretically the efficiency of IC engines increases when the compression ratio is increased, why don't we increase this ratio too much? Explain. [2] (C2) (b) In a Diesel cycle, Compression begins at 0.15 MPa, 45 degrees C. The heat added is 1.75 MJ/kg and the compression ratio is 18. Determine: [6] (C3) (i) the maximum temperature in the cycle, (ii) work done per kg of air (iii) the cycle efficiency (iii) the temperature at the end of the isentropic expansion (iv) the cut-off ratio, and (v) the MEP of the cycle. (C_p and C_v of air are 1.005 and 0.718 kJ/kg.K, respectively, and Gas Constant of Air, R = 287 J/kg. K) Q5. (a) Describe the working principle of the Vapor Compression Refrigeration Cycle with proper diagram. [3] (C3) (b) A simple vapor compression refrigeration cycle uses refrigerant-134a as the working fluid and operates between 0.12 and 1 MPa. If the mass flow rate of the refrigerant is 0.05 kg/s, Determine: [5] (C3) i. the rate of heat removal from the refrigerated space and the power input to the compressor, ii. the rate of heat rejection to the environment, and iii. the COP of the refrigerator.