Skip to content

Electronics II

EEE · Midterm · Summer 26

Paper 1 of 2Section A · Batch 251Switch

Section A · Batch 251

Paper 1 of 2

This browser can’t show the PDF here

Open it, and your phone’s PDF viewer takes it, or download it.

Read the questions as text

Read off the PDF by AI, so it may have mistakes. The PDF is the original.

Daffodil International University Department of Electrical and Electronic Engineering, Faculty of Engineering Mid-Term Examination, Summer-2026 Course Code: 0714-221 Section: All Full Marks: 25 Course Title: Electronics II Level-Term: L2-T2 Date: July-04, 2026 Teacher's Initial: SR Time: 1.5 Hours Answer all of the below questions Q1. Design an Automatic Street lamp circuit using Op-Amp (as comparator) and using LDR (as light sensor). And explain its operation mathematically. (At night lamp will automatic on and at day automatically off) Q2. Analyze the below bridge amplifier circuit and determine the voltage gain vo / vi. [Figure: Bridge amplifier circuit with two op-amps, resistors 30 k-ohm, 60 k-ohm, 20 k-ohm, 50 k-ohm, RL, and voltage source vi] Q3. Design an analog computer circuit using Op-Amp to solve the below differential equation 3 (d^2 vi / dt^2) + 4 (d vi / dt) + 7 int vi + 5 vi = vo, Where vo is the output and vi is the input signal. Q4. Analyze the below instrumentation amplifier circuit and derive an expression for vo in terms of v1 and v2. Describe how can this circuit be used as a subtractor? [Figure: Instrumentation amplifier circuit with two input voltages v1, v2, op-amps, and resistors R1, R2, R3, R4, output vo] Q5. The triangular waveform in Fig. (a) is applied to the input of the op-amp differentiator in Fig. (b). Calculate the output and Show the output waveform. [Figure: (a) Triangular waveform graph with time t(s) from 0 to 4 and voltage vi(t) from -2 to 2. (b) Op-amp differentiator circuit with 0.01 microfarad capacitor and 20 k-ohm feedback resistor]