Skip to content

Electronics II

EEE · Final · Spring 26

Section A · Batch 251

This browser can’t show the PDF here

Open it, and your phone’s PDF viewer takes it, or download it.

Read the questions as text

Read off the PDF by AI, so it may have mistakes. The PDF is the original.

Daffodil International University Department of Electrical and Electronic Engineering, Faculty of Engineering Final Examination, Spring - 2026 Course Code: 0714-221 Course Title: Electronics II Section: A, B, C, D, E Level-Term: L2-T2 Teacher's Initial: SR, KAM Full Marks: 40 Date: April 26, 2026 Time: 2.00 Hours [Notes: Answer all the following questions. The right most column indicates COs and the allocated marks.] Q1. i) Design a first order active high pass filter with a high-frequency gain of 5 and a cutoff frequency of 5 kHz. Use a 0.2 uF capacitor in your design. ii) In a certain application, a simple RC lowpass filter needed to design to reduce high frequency noise. Design a first order lowpass active filter with a maximum gain of 10 and a cutoff frequency of 500 Hz. Q2. i) Obtain the transfer function of the active filter in below Fig. What kind of filter is it? Also find the cutoff frequency if the value of Rf=Ri= 10 kΩ and Cf=Ci= 10 uF. [Figure: An active filter circuit with an op-amp, input resistor Ri, feedback resistor Rf, input capacitor Ci, and feedback capacitor Cf] ii) Design and Analyze a series R-L-C Circuit based passive filter and find the transfer function and from transfer function determine what kind of filter is it? Also find the cutoff frequencies and Resonance Frequency of the designed filter circuit. Q3. i) Design a Colpitt oscillator to produce a sine wave of frequency 88.6 MHz, use Capacitors of C tank circuit C1=50 pF and C2=100 pF. And find the feedback fraction mf. (Find the parameter values and Draw the Complete Designed Circuit). And discuss Barkhausen Criterion (Avmf=1) for Oscillator. ii) Design an astable multivibrator using a 555 Timer IC to generate a square wave suitable for blinking an LED. Desired frequency, f=2 Hz, Duty cycle ≈ 60%, Supply voltage Vcc=9 V. Q4. i) Analyze that the Voltage gain with negative feedback of an amplifier is Auf = Av / (1 + Av mf), where the gain of the amplifier without feedback is Av and feedback fraction is mf. And Discuss the advantages of Negative Voltage Feedback. ii) An amplifier has a voltage amplification Av and a fraction mf of its output is feedback in opposition to the input. If mf=0.1 and Av=200, calculate the percentage change in the gain of the system if Av falls 5 db due to ageing.