Electronics II
EEE · Midterm · Fall 25
Section A, B, C
Read the questions as text
Read off the PDF by AI, so it may have mistakes. The PDF is the original.
Daffodil International University
Department of Electrical and Electronic Engineering, Faculty of Engineering
Mid Term Examination, Fall - 2025
Course Code: 0714-221
Section: A, B, C
Full Marks: 25
Course Title: Electronics II
Level-Term: L2-12
Date: Oct. 18, 2025
Teacher's Initial: SR
Time: 1.5 Hours
[Notes: Answer all the following questions]
Q1. Determine the output voltage v_o in the Op-Amp circuit of below Fig. 1.
[Figure: A multi-stage op-amp circuit containing three op-amps, resistors, and DC voltage sources of 2 V and 3 V]
Q2. Design a temperature threshold alarm using an LM741 as a comparator.
- A sensor provides 10 mV/°C output (0 V at 0 °C).
- The system should trigger (output goes HIGH) when the temperature exceeds 40°C.
- The LM741 is powered from +/- 12 V.
- Assume the sensor output goes to the non-inverting input.
- Use a resistor divider from the +12 V supply to generate the reference voltage.
Tasks:
1. Draw the comparator circuit with LM741.
2. Calculate the reference voltage that corresponds to 40 °C.
3. Choose suitable resistor values (>= 10 kΩ) for the divider to generate this reference voltage.
4. Show the output condition when the temperature is:
o (a) 35 °C
o (b) 45 °C
Q3. I. If an OP-Amp differential amplifier has Common-Mode Rejection Ratio (CMRR) = 80 dB and differential gain (A_d) = 200, determine the common-mode gain (A_cm).
II. Design a circuit to amplify the difference between two input signal by 2. (a) Use only one op amp. (b) Use two op amps. All resistances must be >= 10 kΩ in your design.
Q4. The waveform in Fig. (b) is applied to the input of the op amp differentiator in Fig. (a). Calculate the output and show the output waveform.
[Figure: (a) An op-amp differentiator circuit with a 0.2 uF capacitor and 5 kΩ resistor, (b) A triangular input voltage waveform ranging from 0 to 8 ms]
Q5. A zero-crossing detector (ZCD) in the below Fig. 2 is designed using an LM741 op-amp with +/- 15 V supply. The input is a sine wave; v_in = 5 sin(2*pi*10kHz*t) volt. The op-amp is configured as a comparator (open-loop ZCD) with no feedback resistor. The LM741 has a typical slew rate of 0.5 V/us.
- Draw the expected input and output waveforms of the zero-crossing detector assuming the op-amp is ideal (infinite slew rate).
- Now consider the real LM741 with slew rate = 0.5 V/us. Calculate the minimum transition time (rise/fall time) for the output swing. Sketch the actual (non-ideal) output waveform of the ZCD considering the finite slew rate. Clearly show how the output edges appear sloped instead of perfectly vertical.
[Figure: Fig. 2: zero-crossing detector (ZCD) circuit diagram with an op-amp, R resistors, and V_in, V_ref=0 sources]