Skip to content

Instrumentation and Control

CSE · Final · Summer 26

Paper 3 of 4Batch 65 · SUPAN ROYSwitch

Batch 65

Paper 3 of 4

This browser can’t show the PDF here

Open it, and your phone’s PDF viewer takes it, or download it.

Read the questions as text

Read off the PDF by AI, so it may have mistakes. The PDF is the original.

Daffodil International University Faculty of Science & Information Technology Department of Computer Science & Engineering Final Examination, Summer 2026 Course Code: CSE325, Course Title: Instrumentation and Control Level: 4 Term: 1 Batch: 65 Time: 02:00 Hrs Marks: 40 Answer ALL Questions [The figures in the right margin indicate the full marks and corresponding course outcomes. All portions of each question must be answered sequentially.] 1. a) Define source and sink node. [2, CO1] b) Explain the error of a type '2' system with unit ramp and unit parabolic input. [2, CO1] 2. a) Apply the concepts of sampling, quantization, and encoding to explain the conversion of an analog signal into a digital signal in a digital measurement system. [6, CO2] b) The circuit shown below uses operational amplifiers to process two closely spaced input voltages (8.00 V and 8.01 V). Identify the output current i_o through the 1 kΩ load resistor. [6, CO2] [Figure: An operational amplifier circuit with two input voltages 8.00 V and 8.01 V connected to op-amps with feedback resistors 20 kΩ and 40 kΩ, and an output current i_o passing through a 1 kΩ load resistor.] c) Apply the working principle of an electro-mechanical pressure measurement system to show how applied pressure is changed into mechanical movement and then into an electrical signal using a suitable transducer. [6, CO2] 3. a) The block diagram of an electronic pacemaker is given in the figure below. Identify the steady state error for unit ramp input when K = 300 and select the value of K for which the steady state error to a unit ramp will be 0.056. [6, CO3] [Figure: Block diagram of a pacemaker with input R(s), a summing junction, a transfer function K / (s + 20), a feedback loop with 1 / s, and output C(s).] b) Solve the signal flow graph using Mason's Gain formula to find the ratio of Y_6/Y_1. [6] [Figure: Signal flow graph showing nodes y_1 to y_6 with branches a_12, a_23, a_34, a_45, a_56, and feedback paths a_35, a_42, a_53.] c) Apply Routh-Hurwitz criterion to the following equation and investigate the stability. s^5 + s^4 + 2s^3 + 2s^2 + 3s + 5 = 0 [6]