Skip to content

Energy Conversion II

EEE · Midterm · Fall 25

Section A, B, C

This browser can’t show the PDF here

Open it, and your phone’s PDF viewer takes it, or download it.

Read the questions as text

Read off the PDF by AI, so it may have mistakes. The PDF is the original.

Daffodil International University Department of Electrical and Electronic Engineering Faculty of Engineering Mid Term Examination, Fall - 2025 Course Code: 0713-223 Course Title: Energy Conversion II Section: A, B, C Level-Term: L2-T2 Teacher's Initial: NR Full Marks: 25 Exam Date: October 12, 2025 Time: 1.5 Hours Notes: Answer all the questions below. Right margin shows the course outcomes and allocated marks. Q1. (a) Describe brushless excitation scheme of synchronous generator with proper diagram that includes a pilot exciter. CO-1 C(2) 5 (b) Describe the two bright and one dark lamp method to synchronize the phase sequence with proper diagrams. CO-1 C(2) 4 Q2. (a) Using phasor diagram, describe the effect of change of excitation of an alternator providing constant power output. CO-2 C(4) 4 (b) Mention the conditions that must be maintained for parallel operation of synchronous generator? CO-2 C(2) 2 Q3. (a) Two alternators A and B operate in parallel and supply a load of 10 MW at 0.8 p.f. lagging (a) By adjusting steam supply of A, its power output is adjusted to 6,000 kW and by changing its excitation, its p.f. is adjusted to 0.92 lag. Find the p.f. of alternator B. (b) If steam supply of both machines is left unchanged, but excitation of B is reduced so that its p.f. becomes 0.92 lead, find new p.f. of A. CO-3 C(4) 4 (b) A 480-V, 50-Hz, Y -connected, six-pole synchronous generator has a per-phase synchronous reactance of 1.0 ̉. Its full-load armature current is 60 A at 0.8 PF lagging. This generator has friction and windage losses of 1.5 kW and core losses of 1.0 kW at 60 Hz at full load. The armature resistance is negligible and the field current has been adjusted so that the terminal voltage is 480 V at no load. (i) Calculate the speed of rotation of this generator. (ii) Determine the terminal voltage of this generator if the following are true, 1. It is loaded with the rated current at 0.8 PF lagging. 2. It is loaded with the rated current at 1.0 PF. 3. It is loaded with the rated current at 0.8 PF leading. (iii) Calculate the efficiency of this generator (ignoring the unknown electrical losses) when it is operating at the rated current and 0.8 PF lagging. (iv) How much shaft torque must be applied by the prime mover at full load? How large is the induced counter torque? (v) Determine the voltage regulation of this generator at 0.8 PF lagging? At 1.0 PF? At 0.8 PF leading? CO-3 C(4) 6