Communication Engineering
EEE · Final · Spring 25
Section A,B,C,D
Read the questions as text
Read off the PDF by AI, so it may have mistakes. The PDF is the original.
Daffodil International University
Department of Electrical and Electronic Engineering
Faculty of Engineering
Term Final Examination, Spring - 2025
Course Code: 0714-311
Course Title: Communication Engineering
Section: A, B, C, D
Level-Term: L2-T2
Teacher's Initial: FHT
Full Marks: 40
Exam Date: June 28, 2025
Time: 2 Hours
CO's represents one of the learning outcomes of the course.
Figures on the right hand side indicate marks allocated for that question.
Answer all Questions
Q1. (a) Sketch DSB signal phi_AM(t) for modulation indices of mu = 0.5 and 1, when m(t) = B cos omega_m t. This case is referred to as tone modulation because the modulating signal is a pure sinusoid (or tone). CO2, C2: 4
(b) Explain the details of rectifier detection of AM demodulation. CO2, C2: 4
Q2. (a) Sketch FM and PM wave for the modulating signal m(t) shown in following Fig.1. The constant k_f and k_p are 2pi x 10^5 and 10 pi respectively, and the carrier frequency is 100 MHz. [Figure: a triangular waveform m(t) with peak amplitude 4, trough -4, and time intervals 4 x 10^-4 and 1]. CO2, C3: 5
(b) An FM signal has a frequency deviation of 5 kHz and a modulating frequency of 1 kHz. Calculate the modulation index and comment on whether the modulation is narrowband or wideband. CO2, C3: 3
Q3. (a) Define pulse amplitude modulation (PAM). Illustrate with an example how an analog signal is converted into a digital signal using PCM. : 6
(b) Classify the sampling technique. : 2
Q4. (a) Determine the peak frequency deviation of a BFSK signal with a mark frequency of 51 kHz and space frequency of 55 kHz, input bit rate of 2 kbps. : 2
(b) Determine the baud necessary to pass a 10 kbps binary signal using amplitude shift keying. : 2
(c) Given the data signal 010011101101 and a sinusoidal carrier, sketch the corresponding ASK, FSK, and BPSK signals. : 4
Q5. (a) Explain the mechanism behind Frequency Division Multiplexing (FDM) that allows multiple signals to share a communication channel and be individually recovered. : 5
(b) Describe the process of asynchronous TDM and how it differs from synchronous TDM. : 3