Skip to content

Continuous Signals and Linear Systems

EEE · Final · Fall 25

This browser can’t show the PDF here

Open it, and your phone’s PDF viewer takes it, or download it.

Read the questions as text

Read off the PDF by AI, so it may have mistakes. The PDF is the original.

Daffodil International University Department of Electrical and Electronic Engineering Faculty of Engineering Final Examination, Fall - 2025 Course Code: EEE-0714-217 Section: A, B, C, D, E Full Marks: 40 Course Title: Continuous Signals & Linear Systems Level-Term: L2-T1 Exam Date: December 24, 2025 Teacher's Initial: MFI Time: 2 Hours Answer all the following Questions Q1. Find the Laplace transform X(s) and sketch the pole-zero plot with the ROC for the signal x(t) = e^(-2t)u(t) + e^(-3t)u(t). Q2. Consider the RC circuit shown in Fig. 1. The switch is closed at t = 0. Assume that there is an initial voltage on the capacitor and v_c(0^-) = v_0. (i) Find the current i(t) and the voltage across the capacitor v_c(t). [Figure: An RC circuit with a DC voltage source, a switch at t=0, a resistor R, and a capacitor C in parallel] Q3. Consider the periodic square wave x(t) shown in Fig. 2. Determine the complex exponential Fourier series and the trigonometric Fourier series of x(t). [Figure: A periodic square wave plot of x(t) versus t with pulses of amplitude 1 from -T_0/4 to T_0/4 and periodic intervals] Q4. Consider a continuous-time LTI system described by dy(t)/dt + 2y(t) = x(t). Using the Fourier transform, find the output y(t) to each of the input signals: (i) x(t) = e^(-t)u(t) (ii) x(t) = u(t). Q5. Derive state variable matrices for the continuous time LTI system given in Fig. 3. [Figure: A continuous time LTI circuit diagram with two loops containing resistors R_1, R_2 and capacitors C_1, C_2]