Skip to content

Energy Conversion II

EEE · Midterm · Summer 26

Paper 2 of 3Section A, B, C, D · Md. Shakib AhammadSwitch

Section A, B, C, D

Paper 2 of 3

This browser can’t show the PDF here

Open it, and your phone’s PDF viewer takes it, or download it.

Read the questions as text

Read off the PDF by AI, so it may have mistakes. The PDF is the original.

Daffodil International University Department of Electrical and Electronic Engineering Faculty of Engineering Mid Term Examination, Summer - 2026 Course Code: 0713-223 Course Title: Energy Conversion II Section: A, B, C, D Level-Term: L2-T2 Teacher's Initial: NR, RS Full Marks: 25 Exam Date: June 27, 2026 Time: 1.5 Hours Notes: Answer all the questions below. The second right most column indicates the course outcomes (COs) with respective Bloom's level and the right most column indicates the allocated marks. Q1. Draw and explain the complete brushless excitation system of a synchronous generator that includes a pilot exciter with the function of each component. CO-1 5 C(2) Q2. Analyze the effect of load changes on a synchronous generator for lagging, unity, and leading power factor loads using phasor diagram. CO-2 5 C(4) Q3. A 100 kVA, 3000 V, 3-phase star-connected alternator has an armature resistance of 0.2 ohm per phase. A field current of 40 A produces a short-circuit current of 200 A and an open-circuit line voltage of 1040 V. CO-2 5 C(4) Analyze how the power factor affects the voltage regulation by determining the full-load voltage regulations and drawing the corresponding phasor diagrams of the alternator at 0.8 power factor lagging and 0.8 power factor leading. Q4. A 480-V, 50-Hz, Y-connected, six-pole synchronous generator has a per-phase synchronous reactance of 1.0 ohm. Its full-load armature current is 60 A at 0.8 PF lagging. CO-3 5 C(5) This generator has friction and windage losses of 1.5 kW and core losses of 1.0 kW at 60 Hz at full load. The armature resistance is negligible and the field current has been adjusted so that the terminal voltage is 480 V at no load. (i) Determine the speed of rotation of this generator. (ii) Evaluate the terminal voltage of this generator if the following are true, 1. It is loaded with the rated current at 0.8 PF lagging. 2. It is loaded with the rated current at 1.0 PF. 3. It is loaded with the rated current at 0.8 PF leading. (iii) Calculate the efficiency of this generator (ignoring the unknown electrical losses) when it is operating at the rated current and 0.8 PF lagging. Q5. Two synchronous generators are operating in parallel supplying a total load of 2.5 MW at 0.8 power factor lagging. Generator 1 has a no-load frequency of 61.5 Hz and a slope of 1 MW/Hz, while Generator 2 has a no-load frequency of 61.0 Hz and a slope of 1 MW/Hz. CO-3 5 C(5) After steady-state operation, an additional 1 MW load is connected and the governor set point of Generator 2 is increased by 0.5 Hz. Evaluate the system frequency and the generator powers before and after the change in system condition. [Figure: Two synchronous generators connected in parallel to loads]