Electronic Devices and Circuits
CSE · Midterm · Summer 25
Paper 2 of 4Batch 66 · ASHIKUR RAHMANSwitch
Batch 66
Paper 2 of 4
Read the questions as text
Read off the PDF by AI, so it may have mistakes. The PDF is the original.
Daffodil International University
Faculty of Science & Information Technology
Department of Computer Science & Engineering
Mid Examination, Summer 2025
Course Code: CSE215 Course Title: Electronic Devices and Circuits
Level: 2 Term: 2 Batch: 66
Time: 1.50 Hrs Full Marks: 25
Answer all the following questions
[All portions of each question must be answered sequentially]
Q1. a. Define hole current. | 1
Q1. b. Recall collector-base current with emitter open (ICBO). | 1
Q1. c. Name the components required to convert pulsating DC into pure DC. | 1 | CO1
Q1. d. Recall the input and output characteristics of common base connection. | 1
Q1. e. Define a clipper circuit and a clamper circuit with respect to their function. | 1
Q2. a. Show by deriving the relevant expressions that the ripple factor in half-wave rectification exceeds that of full-wave rectification by approximately 2.5 times. | 4 | CO2
Q2. b. Explain the formation of potential barrier in a pn junction with necessary figure. | 4
Q3. a. A transistor is operating in a common-emitter configuration. The collector supply voltage is 12 V, and the voltage drop across the collector resistor RC (which has a resistance of 1 kΓ̉) is 2 V. Given that the transistor's common-base current gain is ̒=0.98. Solve for:
i) The collector-emitter voltage VCE
ii) The base current IB | 4 | CO3
Q3. b. A Full-Wave rectifier uses two diodes, the internal resistance of each diode may be assumed constant at 20 Γ̉. If the peak inverse voltage is 150 V & load resistance is 980 Γ̉ then solve it to get the followings:
i) Mean load current
ii) R.M.S. value of load current | 4
Q3. c. Solve for the maximum and minimum values of Zener diode current for the given circuit below. Here, three Zener diodes of 20V are connected in series in Fig.1. | 4
[Figure: A circuit diagram showing a DC voltage source ranging from 60 V to 120 V connected in series with a 5 kΓ̉ resistor and three 20V Zener diodes in series, all in parallel with a 10 kΓ̉ load resistor]