Skip to content

Electronic Devices and Circuits

CSE · Midterm · Summer 25

Paper 3 of 4Batch 66 · Ferdosh RiyadSwitch

Batch 66

Paper 3 of 4

This browser can’t show the PDF here

Open it, and your phone’s PDF viewer takes it, or download it.

Read the questions as text

Read off the PDF by AI, so it may have mistakes. The PDF is the original.

Daffodil International University Faculty of Science & Information Technology Department of Computer Science & Engineering Mid Examination, Summer 2025 Course Code: CSE215 Course Title: Electronic Devices and Circuits Level: 2 Term: 2 Batch: 66 Time: 1.50 Hrs Full Marks: 25 Answer all the following questions [All portions of each question must be answered sequentially] Q1. a. Define hole current. | 1 | CO1 Q1. b. Recall collector-base current with emitter open (ICBO). | 1 Q1. c. Name the components required to convert pulsating DC into pure DC. | 1 Q1. d. Recall the input and output characteristics of common base connection. | 1 Q1. e. Define a clipper circuit and a clamper circuit with respect to their function. | 1 Q2. a. Show by deriving the relevant expressions that the ripple factor in half-wave rectification exceeds that of full-wave rectification by approximately 2.5 times. | 4 | CO2 Q2. b. Explain the formation of potential barrier in a pn junction with necessary figure. | 4 Q3. a. A transistor is operating in a common-emitter configuration. The collector supply voltage is 12 V, and the voltage drop across the collector resistor RC (which has a resistance of 1 kΩ) is 2 V. Given that the transistor's common-base current gain is alpha = 0.98. Solve for: | 4 | CO3 i) The collector-emitter voltage VCE ii) The base current IB Q3. b. A Full-Wave rectifier uses two diodes, the internal resistance of each diode may be assumed constant at 20 Ω. If the peak inverse voltage is 150 V & load resistance is 980 Ω then solve it to get the followings: | 4 i) Mean load current ii) R.M.S. value of load current Q3. c. Solve for the maximum and minimum values of Zener diode current for the given circuit below. Here, three Zener diodes of 20V are connected in series in Fig.1. | 4 [Figure: Circuit diagram showing a DC voltage source ranging from 80 V - 120 V connected in series with a 5 kΩ resistor, three Zener diodes of 20V each connected in series, and a 10 kΩ parallel load resistor]