Skip to content

Engineering Materials

CE · Final · Spring 25

This browser can’t show the PDF here

Open it, and your phone’s PDF viewer takes it, or download it.

Read the questions as text

Read off the PDF by AI, so it may have mistakes. The PDF is the original.

Daffodil International University B. Sc. in Civil Engineering Final Examination, Spring - 2025 Course Code: CE 201 Course Title: Engineering Materials Section: BN1 & BN2 Level-Term: 2-1 Teacher's Initial: AU Full Marks: 40 Date: May 22, 2025 Time: 2.0 Hours Note: There are eight questions in total. Answer all of them. Right hand margin indicates full marks. 1. The combined fineness modulus of fine aggregate (FA) and coarse aggregate (CA), having values of 2.85 and 6.77 respectively, was found to be 5.30. If 8.49 cubic feet of well-packed combined aggregate is required, Calculate the initial volumes of FA and CA to be mixed. Assume a shrinkage factor of 0.75. [CO2, C3] [05] 2. Design a concrete mix for column located above ground where moderate freezing and thawing may occur. The required average strength will be 4500psi. The coarse aggregate has a nominal maximum size of 25 mm and a dry-rodded mass of 100 lb/ft^3. The other properties of the ingredients are as follows: - Cement: Type I with a specific gravity of 3.15. - Coarse aggregate: bulk specific gravity = 2.70, absorption = 1.2% and surface moisture = 1.5 %. - Fine aggregate: bulk specific gravity = 2.60, absorption = 1%, fineness modulus = 2.7, and surface moisture = 2 %. [CO3, C5] [10] 3. Briefly demonstrate the causes and control measures of segregation in concrete. [CO2, [04] C3] 4. Illustrate the stress-strain curve of mild steel. [CO1, C2] [03] 5. Write short note on the following: [CO1, C1] [08] I. Light weight concrete II. Ingredients of paints III. FRP IV. Uses of Ferrocement 6. Briefly describe the main objectives of timber seasoning. [CO1, C1] [03] 7. Briefly describe the factors affecting the strength of concrete. [CO1, C2] [04] 8. Briefly describe, with a neat sketch, the relationship between the water-to-cement ratio and the compressive strength of concrete. [CO1, C2] [03]