Electrical Circuits I
EEE · Midterm · Fall 25
Read the questions as text
Read off the PDF by AI, so it may have mistakes. The PDF is the original.
Daffodil International University
Department of Electrical and Electronic Engineering
Faculty of Engineering
Mid-Term Examination, Fall - 2025
Course Code: 0713-111
Course Title: Electrical Circuit I
Section: A, B, C, D, E, F, G, H
Level-Term: L1-T1
Teacher's Initial: MRK, FHT
Full Marks: 25
Exam Date: October 15, 2025
Time: 1.5 Hours
[Answer all questions. Figures in the right margin indicates full marks.]
Q1. (a) State and explain KCL and KVL. CO1 2 C(1)
(b) Calculate the I and V_ab for the circuit shown in Fig.1. CO1 3 C(2)
[Figure: A single loop circuit with a 30 V source, a 3 ohm resistor, a 10 V source, nodes a and b with V_ab across them, a 5 ohm resistor, and an 8 V source with current I flowing through it]
Q2. Find v_1 and v_2 in the circuit shown in Fig. 2. Also, calculate i_1 and i_2 and the power dissipated in the 12-Ω and 40-Ω resistors. CO1 5 C(2)
[Figure: A circuit with a 15 V source, a 12 ohm resistor with current i_1, a 6 ohm resistor, a 10 ohm resistor, and a 40 ohm resistor with current i_2 and voltage v_2]
Q3. Obtain the equivalent resistance for the circuit in Fig. 3 and use it to find current i. CO1 5 C(2)
[Figure: A bridge-like resistor network with a 220 V source supplying current i, having resistors 12.5 ohm, 15 ohm, 10 ohm, 20 ohm, 5 ohm, and 30 ohm]
Q4. Using nodal analysis, find v and i in the circuit shown of following Fig.4. CO2 5 C(3)
[Figure: A circuit diagram with a 21 V source, a 4 ohm resistor, a 3 ohm resistor with voltage v, a 9 V source, a 2 ohm resistor, a 6 ohm resistor, and current i]
Q5. Apply mesh analysis to find the current i_o in the circuit shown in Fig. 5. CO2 5 C(3)
[Figure: A circuit with three meshes containing a 20 V source, current source i_o, 4 ohm, 6 ohm, 2 ohm, 8 ohm resistors, and a dependent source 10 i_o]