Skip to content

Electrical Circuits I

EEE · Final · Fall 24

This browser can’t show the PDF here

Open it, and your phone’s PDF viewer takes it, or download it.

Read the questions as text

Read off the PDF by AI, so it may have mistakes. The PDF is the original.

Daffodil International University Department of Electrical and Electronic Engineering Faculty of Engineering Final-Term Examination, Fall-2024 Course Code: 0713-111 Course Title: Electrical Circuits I Section: A, B, C, D, E & F Level-Term: L1-T1 Teacher's Initial: MAH, KZ Full Marks: 40 Exam Date: December 17, 2024 Time: 2:00 Hours [Notes: Answer all the following questions. CO's represent one of the learning outcome of the course. Figures on the right hand side indicate marks allocated for the questions.] Q1(a) For the circuit in Fig.1, i(t) = 4(2 - e^-10t) mA. If i2(0) = -1 mA, find: (a) i1(0); (b) v(t), v1(t), and v2(t); (c) i1(t) and i2(t) [Figure: Circuit diagram showing inductors, current, and voltage labels, Fig.1] CO-3 (C4) [5] (b) In Fig.2, the switch has been closed for a long time and is opened at t = 0. Find i and v for all time. [Figure: Circuit diagram showing a DC voltage source, resistors, capacitor, inductor, switch, and terminals, Fig.2] CO-3 (C4) [5] Q2(a) Prove the conversion: RA = 3RY. CO-2 (C3) [5] (b) Find the total resistance of the Fig.3 where RA = 3 ohms, RB = 3 ohms, and RC = 6 ohms. [Figure: Bridge circuit diagram with resistors labeled R1, RA, RB, RC, and nodes a, b, c, Fig.3] CO-2 (C3) [5] Q3(a) Find V_x in Fig.4 using source transformation. [Figure: Circuit diagram with independent sources, dependent source, and resistors, Fig.4] CO-2 (C3) [5] (b) Find the Norton equivalent circuit for the circuit in Fig.5 at terminals a-b. [Figure: Circuit diagram with independent voltage source, dependent or independent current source, and resistors, Fig.5] CO-2 (C3) [5] Q4(a) Prove that maximum power is transferred to the load when the load resistance equals the Thevenin resistance as seen from the load (RL = R_TH) and also find the equation of maximum power delivered to the load. CO-2 (C3) [5] (b) Determine the value of R_L that will draw the maximum power from the rest of the circuit in Fig.6. Calculate the maximum power. [Figure: Circuit diagram with voltage source, resistors, and dependent source connected to load R_L, Fig.6] CO-2 (C3) [5]