Skip to content

Energy Conversion I

EEE · Midterm · Summer 26

Paper 1 of 3By S. M. Fazla RabbySwitch

Paper 1 of 3

This browser can’t show the PDF here

Open it, and your phone’s PDF viewer takes it, or download it.

Read the questions as text

Read off the PDF by AI, so it may have mistakes. The PDF is the original.

Daffodil International University Department of Electrical and Electronic Engineering Faculty of Engineering Mid-Term Examination, Summer - 2026 Course Code: 0713-213 Course Title: Energy Conversion I Section: A/B/C/D/E/F/G Level-Term: L2-T1 Teacher's Initial: DRA / PA / RS Full Marks: 25 Exam Date: July 4, 2026 Time: 1.5 Hours Attempt to Answer all 3 Questions Q1. a) Draw the phasor diagram of a inductively loaded transformer with winding resistance and but no magnetic leakage reactance CO-1 [3] C(3) b) The core of a 100-kVA, 11500/550 V, 50-Hz, 1-ph, core type transformer has a cross-section of 22 cm x 22 cm. Determine (i) the number of H.V. and L.V. turns per phase and (ii) the e.m.f. per turn if the maximum core density is not to exceed 1.5 Tesla. Assume a stacking factor of 0.9. CO-1 [4] C(3) Q2. a) Explain the purpose of Short-Circuit Test in a Transformer with necessary diagrams and associated equations. CO-1 [3] C(2) b) A transformer has a primary winding of 840 turns and a secondary winding of 200 turns. When the load current on the secondary is 75 A at 0.85 power factor lagging, the primary current is 20 A at 0.9 power factor lagging. Calculate the no-load current of the transformer and its phase with respect to the voltage. CO-1 [5] C(3) Q3. Answer any 2 (Two) from the following questions: a) A 50-kVA, 4500/220 V transformer has R1 = 4.45 ohms, R2 = 0.009 ohms. The values of reactances are X1 = 5.2 ohms and X2 = 0.017 ohms. Compute for the transformer (i) equivalent resistance as ref. to primary (ii) equivalent resistance as ref. to secondary (iii) equivalent reactance as ref. to both primary and secondary (iv) equivalent impedance as ref. to both primary and secondary (v) total Cu loss of the transformer. CO-2 [5] C(3) b) The data refer to a 1-phase transformer are: Turn ratio 19.5:2; R1 = 30 ohms; X1 = 100 ohms; R2 = 0.08 ohms; X2 = 0.25 ohms. No-load current = 1.3 A, leading the flux by 30 degrees. The secondary delivers 210 A at a terminal voltage of 500 V and p.f. of 0.8 lagging. Determine the primary current and applied voltage. CO-2 [5] C(4) c) Obtain the equivalent circuit of a 250/520-V, 50-Hz, single-phase transformer from the following test data: O.C Test : 250 V, 1.2 A, 80 W - on L.V. side S.C. Test : 22 V, 12 A, 110 W - on H.V. side Find the equivalent circuit of the transformer and calculate the secondary terminal voltage when delivering a load current of 15 A at pf of 0.8 lagging, the primary voltage being 250 V. CO-2 [4] C(4)