Skip to content

Energy Conversion I

EEE · Midterm · Fall 25

This browser can’t show the PDF here

Open it, and your phone’s PDF viewer takes it, or download it.

Read the questions as text

Read off the PDF by AI, so it may have mistakes. The PDF is the original.

Daffodil International University Department of Electrical and Electronic Engineering Faculty of Engineering Mid-Term Examination, Fall - 2025 Course Title: Energy Conversion I Course Code: 0713-213 Level-Term: L2-T1 Teacher's Initial: DRA, BS Section: A, B, C, D, E Exam Date: October 11, 2025 Time: 1.5 Hours Full Marks: 25 Attempt to Answer all 4 Questions Q1. a) Derive the EMF equation of a single-phase transformer with supporting diagram. CO-1 3 C(2) b) A single-phase transformer has a primary winding of 1000 turns and a secondary winding of 280 turns. The load current on the secondary is 60 A at pf 0.707 lagging and the primary current is 30 A at pf 0.85 lagging. Determine the no-load current and the no-load power factor of the transformer. CO-1 4 C(3) Q2. a) "Whatever the load conditions, the net flux passing through the core is approximately the same as at no-load" - Justify the statement with necessary figures. CO-1 3 C(2) b) A 50 kVA, 4,400/200-V, 50-Hz transformer has a high voltage winding resistance of 0.12 ohm and a leakage reactance of 0.222 ohm. The low voltage winding resistance is 0.035 ohm and the leakage reactance is 0.012 ohm. CO-1 4 C(3) i) Determine the equivalent winding resistance, reactance and impedance referred to the high voltage side and the low-voltage side. ii) Calculate the total Cu loss of the transformer. Q3. a) Sketch the vector diagram of a transformer connected at lagging load considering both winding resistance and leakage reactance. CO-2 2 C(3) b) Find the equivalent circuit parameters of a 10 kVA, 240/400 V, 50 Hz, single-phase transformer was tested with the following results: CO-2 4 C(5) O.C. Test : 240 V, 1.2 A, 90 W - on LV side S.C. Test: 15 V, 4.7 A, 110 W - LV side is shorted Calculate the output secondary voltage of the transformer when delivering a load of 1 kW at pf 0.85 lagging and the primary is supplied at 240 V. Q4. The following data refer to a single-phase transformer: Turn ratio 20 : 1; R1 = 30 ohm; X1 = 100 ohm; R2 = 0.08 ohm; X2 = 0.3 ohm. No-load current = 1.8 A leading the flux by 25 degree. The secondary delivers 200 A at a terminal voltage of 520 V and p.f. of 0.8 lagging. Determine the primary induced e.m.f and primary current. CO-2 5 C(3) OR A 100 kVA transformer has 450 turns on the primary and 80 turns on the secondary. The primary and secondary resistances are 0.35 ohm and 0.01 ohm respectively and the corresponding leakage reactances are 1.3 and 0.035 ohm respectively. The supply voltage is 2100 V. Calculate (i) equivalent impedance referred to primary and (ii) the voltage regulation and the secondary terminal voltage for full load having a power factor of 0.9 leading. CO-2 5 C(3)