Energy Conversion I
EEE · Quiz · Spring 25
Read the questions as text
Read off the PDF by AI, so it may have mistakes. The PDF is the original.
Daffodil International University
Dept. of Electrical and Electronic Engineering
Spring 2025 | 0713-213: Energy Conversion I
Quiz - 1
19 February 2025
Full Marks: 20.0
CO-1
1. Prove that - whatever the load conditions, the net flux in the core is approximately the same as at no-load. [3]
2. A single-phase transformer has 1000 primary and 480 secondary turns. The net cross-sectional area of the core is 850 cm^2. If the primary winding be connected to a 50-Hz supply at 1100 V, calculate (i) the peak value of flux density in the core (ii) the voltage induced in the primary and secondary windings. [3]
3. A single-phase transformer has 80 turns in secondary and 320 turns in primary. The no-load power factor is 0.1736 lagging and the magnetizing component of no-load primary current is 4.7 A. If the load component of primary current (I'_2) is 35 A at 0.891 lagging, determine the no-load current (I_0) and the current delivers by secondary (I_2). [5]
4. Draw the phasor diagram of a resistively loaded transformer by considering both winding resistance and leakage reactance. [4]
5. A 20 kVA, 2400/220 V, 50 Hz transformer has a high-voltage winding resistance of 0.15 ohm and a leakage reactance of 0.4 ohm. The low-voltage winding has a resistance of 0.05 ohm and a leakage reactance of 0.025 ohm. Find the equivalent winding resistance, reactance and impedance referred to the (i) high-voltage side and (ii) the low-voltage side and (iii) total Cu loss of the transformer. [5]