Electronics I
EEE · Midterm · Summer 26
Paper 1 of 2By Ashik 152Switch
Paper 1 of 2
Read the questions as text
Read off the PDF by AI, so it may have mistakes. The PDF is the original.
Daffodil International University
Department of Electrical and Electronic Engineering
Faculty of Engineering
Mid-Term Examination, Summer'26
Course Code: 0714-211
Course Title: Electronics I
Teacher's Initial: SD, KNA, KAH, MH
Section: A, B, C, D, E, F, G
Level-Term: L2-T1
Full Marks: 25
Exam Date: July 01, 2026
Time: 1.5 Hours
[There are five (05) questions, answer all of them.]
[The second right most column indicates the COs with respective Bloom's level.]
[The right most column indicates the assigned marks.]
Q1. Suppose you need to construct a counter for counting products in a factory setup. Which type of Diode will you use for this case? Explain its working principle and how the diode is used for counting products with necessary diagrams. | CO-1 | [5]
| C(2) |
Or
Describe the working principle of an n channel JFET with necessary diagrams. | CO-1 | [5]
| C(2)
Q2. Describe the operation of a Center-tapped Transformer Full Wave Rectifier with necessary diagrams. If the input to a Center-tapped Transformer [turns ratio 1:2] full wave rectifier made with Si diode is 120sin 60t V, determine (i) Average dc output voltage, (ii) PIV of the diodes. | CO-2 | [5]
| C(2)
Q3. Determine I_D1, I_D2, I_D3 and V_O for the following circuit in Fig. Q3. | CO-2 | [5]
| C(3)
[Figure: Circuit diagram for Fig. Q3 with V_i = 10 V, R_1 = 4 kΩ, R_2 = 8 kΩ, R_3 = 6 kΩ, R_4 = 4 kΩ, Si diode D_1, D_2 with 1.0 V, D_3 with 2.0 V]
Q4. Determine and sketch the output signal of the following clipper circuit in Fig. Q4 for the given input signal. | CO-2 | [5]
| C(3)
[Figure: Clipper circuit with input sinusoidal wave +20 V to -20 V, R = 1 kΩ, Si diode, DC source 6 V]
Q5. For the following circuit in Fig. Q5, determine: | CO-2 | [5]
(i) The minimum value of R_L to ensure that the Zener Diode is in the "on" state. | C(3)
(ii) The value of R_L that will establish maximum power conditions for the Zener diode.
(iii) The range of I_L when V_L is being maintained at 24 V.
[Figure: Zener diode circuit with V_i = 40 V, R_S = 440 Ω, V_Z = 24 V, P_Zmax = 800 mW, V_L = 24 V]