Instrumentation and Control
CSE · Midterm · Summer 26
Paper 1 of 2Batch 65 · mahi_232_Switch
Batch 65
Paper 1 of 2
Read the questions as text
Read off the PDF by AI, so it may have mistakes. The PDF is the original.
Daffodil International University
Faculty of Science & Information Technology
Department of Computer Science & Engineering
Midterm Examination, Summer 2026
Course Code: CSE 325, Course Title: Instrumentation and Control
Level: 4 Term: 1 Batch: 65
Time: 01:30 Hrs
Marks: 25
Answer ALL Questions
[The figures in the right margin indicate the full marks and corresponding course outcomes. All portions of each question must be answered sequentially.]
1. a) Define accuracy and precision with an example. | 1 | CO1
b) What is the difference between open loop and close loop control system? | 1 |
c) Recall the significance of shunt resistance in an ammeter? | 1 |
d) Illustrate feedback network in control system. | 1 |
e) State the function of PT. | 1 |
2. a) Figure 2(a) shows an Aryton shunt of an ammeter with a current range of 0-1 mA, 0-10 mA, 0-50 mA and 0-100 mA. A PMMC meter movement with an internal resistance of 100 ohms and full-scale current of 50 microA is used. Calculate the value of Ra, Rb, Rc and Rd.
[Figure: Circuit diagram of an Aryton shunt with 4 ranges: 1mA, 10mA, 50mA, 100mA, containing resistors Ra, Rb, Rc, Rd and a PMMC meter movement] | 5 | CO2
b) A half-wave rectifier type AC meter using a PMMC movement suffers from two major disadvantages:
i) Demonstrate the causes of these disadvantages in a half-wave rectifier AC meter.
ii) Demonstrate how an improved rectifier-based AC meter eliminates these disadvantages. | 2+3 |
3. a) For the circuit in Figure 3(a) develop equivalent block diagram.
[Figure: Series-parallel RLC circuit with voltage source v(t), resistors R1 and R2, inductor L, and capacitor C with voltage vc(t)] | 5 | CO3
b) Apply block diagram reduction techniques to determine the transfer function of the system shown in Figure 3(b), T(s) = C(s)/R(s).
[Figure: Block diagram containing blocks G1, G2 and feedback paths H1, H2, H3 with multiple summing junctions] | 5 |