Skip to content

Instrumentation and Control

CSE · Midterm · Summer 26

Paper 2 of 2Batch 65 · SUPAN ROYSwitch

Batch 65

Paper 2 of 2

This browser can’t show the PDF here

Open it, and your phone’s PDF viewer takes it, or download it.

Read the questions as text

Read off the PDF by AI, so it may have mistakes. The PDF is the original.

Daffodil International University Faculty of Science & Information Technology Department of Computer Science & Engineering Midterm Examination, Summer 2026 Course Code: CSE 325, Course Title: Instrumentation and Control Level: 4 Term: 1 Batch: 65 Time: 01:30 Hrs Marks: 25 Answer ALL Questions [The figures in the right margin indicate the full marks and corresponding course outcomes. All portions of each question must be answered sequentially.] 1. a) Define accuracy and precision with an example. | 1 | CO1 b) What is the difference between open loop and close loop control system? | 1 | CO1 c) Recall the significance of shunt resistance in an ammeter? | 1 | CO1 d) Illustrate feedback network in control system. | 1 | CO1 e) State the function of PT. | 1 | CO1 2. a) Figure 2(a) shows an Aryton shunt of an ammeter with a current range of 0-1 mA, 0-10 mA, 0-50 mA and 0-100 mA. A PMMC meter movement with an internal resistance of 100 ̉ and full-scale current of 50 A is used. Calculate the value of Ra, Rb, Rc and Rd. | 5 | CO2 [Figure: Aryton shunt circuit diagram with input and range switch for 1 mA, 10 mA, 50 mA, 100 mA and resistors Ra, Rb, Rc, Rd connected to a PMMC meter] b) A half-wave rectifier type AC meter using a PMMC movement suffers from two major disadvantages: | 2+3 | CO2 i) Demonstrate the causes of these disadvantages in a half-wave rectifier AC meter. ii) Demonstrate how an improved rectifier-based AC meter eliminates these disadvantages. 3. a) For the circuit in Figure 3(a) develop equivalent block diagram. | 5 | CO3 [Figure: RLC circuit with voltage source v(t), resistors R1 and R2, inductor L, and capacitor C with voltage vc(t)] b) Apply block diagram reduction techniques to determine the transfer function of the system shown in Figure 3(b), T(s) = C(s) / R(s). | 5 | CO3 [Figure: Block diagram of a control system with blocks G1, G2, feedback paths H1, H2, H3, and summing junctions]