Electrical Circuits II
EEE · Final · Spring 25
Read the questions as text
Read off the PDF by AI, so it may have mistakes. The PDF is the original.
Daffodil International University
Department of Electrical and Electronic Engineering
Faculty of Engineering
Final Examination, Spring - 2025
Course Code: 0713-121
Course Title: Electrical Circuits II
Section: A, B, C, D, E, F
Level-Term: L1-T2
Teacher's Initial: MSA, SZE
Full Marks: 40
Exam Date: March 21, 2025
Time: 2 Hours
Question No. 1 and 2 are COMPULSORY. Answer any 3 (THREE) from the rest of the Questions
Q1. (a) State Thevenin's Theorem. Derive the condition for maximum power transfer in Thevenin's equivalent circuit. CO-2 C (3) [04+04 = 08]
(b) Find Norton's impedance and current of the circuit in Figure 1(b)
[Figure: A circuit with a 3/60 degree A current source in parallel with a 60 ohm resistor and -j80 ohm capacitor, connected across terminals a and b to a load consisting of a 40 ohm resistor in series with a -j30 ohm capacitor.]
Q2. (a) Identify the type of filter the circuit in Figure 2(a) works as. What will be the corner frequency if R1= 200 ohm, R2= 70 ohm and L= 0.1 H. CO-3 C (6) [04+04 = 08]
[Figure: An operational amplifier filter circuit with input Vin, resistors R1 and R2, inductor L3, and output Vo.]
(b) The Quality factor of a band-pass filter circuit is 20. If the resonant frequency of the circuit is 3 kHz, then design the circuit with appropriate values of R and C. Note that inductance, L = 0.1 H
Q3. (a) Show that the summation of balanced three-phase voltages is zero. CO-2 C (3) [02+06 = 08]
(b) Calculate vo of the circuit in Figure 3(b).
[Figure: An AC circuit containing a 12 cos 3t V source, a 6 ohm resistor, a 1/(2F) capacitor, a vo node, a 4 sin 2t A current source, a 2 H inductor, and a 2vo dependent source.]
Q4. (a) Sketch the ideal and actual frequency response of a band-stop filter circuit with proper labeling. CO-2 C (3) [02+06 = 08]
(b) Calculate the line currents and total complex power of the load of the 3-phase unbalanced circuit given in Figure 4(b). The circuit is operating in abc sequence Van = 220<0 degree V.
[Figure: A three-phase unbalanced star-connected load with line voltages, line impedances j2 ohm, -j15 ohm, j8 ohm, and load impedances 12 ohm.]
Q5. (a) State Kirchhoff's Current Law with an example. CO-2 C (3) [02+02]
(b) Derive the relation between line current and phase current in a delta-connected system. CO-3 [04+08]
(c) Compute Vo of the circuit in Figure 5(c) using Nodal Analysis.
[Figure: A circuit containing a 12/0 degree V source in series with a 2 ohm resistor, a 2 ohm resistor, a 4 ohm resistor, -j4 ohm capacitor, 2 ohm resistor, 0.2Vo dependent source, and output Vo.]
Q6. (a) In a balanced Delta-Y circuit, Vab = 150<30 degree and the per-phase impedance, ZY = (3 - j6) ohm. Find the line voltages, line currents, total power, and power factor of the system if the circuit operates in negative sequence. CO-2 C (3) [04+04 = 08]
(b) A three-phase Delta-connected motor takes 10KVA power with 0.75 power factor (lagging). The motor is connected to a Y load of 10 ohm resistance and 18 ohm capacitive reactance connected in series in each phase. Calculate the total Volt-Amperes, power factor, and line current of the circuit.
Q7. (a) Show that in a three-phase system, ZL = 3ZY. CO-2 C (3) [02+06 = 08]
(b) Use Mesh Analysis to find the current Io flowing in the circuit in Figure 7(b).
[Figure: A mesh circuit with 2<0 degree A source, 1 ohm resistor, j2 ohm inductor, 2 ohm resistor, -j4 ohm capacitor, 4<0 degree A source, 1 ohm resistor, 10<90 degree V source, and mesh current Io.]