Skip to content

Electronics I

EEE · Midterm · Spring 25

Section A, B, C

This browser can’t show the PDF here

Open it, and your phone’s PDF viewer takes it, or download it.

Read the questions as text

Read off the PDF by AI, so it may have mistakes. The PDF is the original.

Daffodil International University Department of Electrical and Electronic Engineering Faculty of Engineering Mid-Term Examination, Spring - 2025 Course Code: 0714-211 Course Title: Electronics I Teacher's Initial: SD Section: A, B, C Level-Term: L2-T1 Time: 1.5 Hours Full Marks: 25 Exam Date: March 15, 2025 [There are five (05) questions, answer all of them.] [The figures in the right-hand margin indicate the allocated marks.] [COs represent learning outcomes of the course.] Q1. (a) Justify the statement - "Semiconductor materials have a negative temperature co-efficient of resistance". CO-1 [2] C(2) (b) Suppose you need to construct a counter for counting products in a factory setup. Find the type of Diode you will need for this case. Also, explain its working principle. CO-1 [3] C(2) Q2. Describe the operation of a Diode Bridge Full Wave Rectifier with necessary diagrams. If the input to a diode bridge full wave rectifier is 20 sin 60t V, determine the output dc voltage and PIV rating of the diodes used in the rectifier. CO-2 [5] C(2) Q3. Determine ID1, ID2 and the voltage at node E for the following circuit in Fig. Q3. Here, both the diodes are made of Silicon. CO-2 [5] C(3) [Figure: Circuit diagram for Q3 showing a +15 V DC source connected through a 5 kOhm resistor to node E, with a parallel branch containing diode D1 to ground and diode D2 leading to node E, and node E connected through a 5 kOhm resistor to a -10 V DC source.] Q4. Determine and sketch the output signal of the following clipper circuit in Fig. Q4 for the given input signal. CO-2 [5] C(3) [Figure: Circuit and input waveform diagram for Q4 showing an input triangular wave varying between +10 V and -10 V, connected to a clipper circuit containing a 4 V DC source, a GaAs diode, and a 1 kOhm resistor across which the output voltage Vo is taken.] Q5. For the following circuit in Fig. Q5: (i) Determine the range of Vi that will maintain VL at 8 V and not exceed the maximum power rating of the Zener diode. CO-2 [5] C(3) (ii) Find the value of VL if Vi is within the range found in (i), but the polarity of the Zener diode is reversed in Fig. Q5. [Figure: Zener diode voltage regulator circuit with a series resistor Rs = 91 Ohm, a Zener diode with Vz = 8 V and Pz_max = 400 mW, and a load resistor RL = 0.22 kOhm across which VL is measured.]