Skip to content

Continuous Signals and Linear Systems

EEE · Final · Summer 26

Paper 1 of 4Batch 253Switch

Batch 253

Paper 1 of 4

This browser can’t show the PDF here

Open it, and your phone’s PDF viewer takes it, or download it.

Read the questions as text

Read off the PDF by AI, so it may have mistakes. The PDF is the original.

Daffodil International University Department of Electrical and Electronic Engineering Faculty of Engineering Final Examination, Summer - 2026 Course Code: 0714-217 Course Title: Continuous Signals & Linear Systems Section: A, B, C, D, E, F, G Level-Term: L2-T1 Teacher's Initial: MFI, SRH Full Marks: 40 Exam Date: August 22, 2026 Time: 2 Hours Answer all the following Questions Q1. Determine the Laplace transform X(s) and illustrate the pole-zero plot with the ROC for the signal x(t) = e^(-3t)u(t) + e^(2t)u(-t). Q2. Consider the RC circuit shown in Fig. 1. The switch is closed at t = 0. Assume that there is no initial voltage on the capacitor. Using Laplace transform determine the step response of the following circuit. [Figure: RC circuit with voltage source V, switch at t=0, resistor R, capacitor C, and voltage vc(t) across it] Q3. The output y(t) of a continuous time LTI system is found to be 2e^(-3t)u(t) when the input is a unit step function. Using Laplace transform Determine the output y(t) when the input x(t) is changed to e^(-t)u(t). Q4. Consider the periodic square wave x(t) shown in Fig. 2. Determine the complex exponential Fourier series and the trigonometric Fourier series of x(t). [Figure: Periodic square wave with period To, amplitudes 1, and pulses from -To/4 to To/4] Q5. If h1 = e^(-2t)u(t) and h2 = 2e^(-t)u(t) then determine the overall impulse response h(t) for the continuous time LTI system given in Fig. 3. [Figure: Block diagram of two systems h1(t) and h2(t) in cascade and a single equivalent system h(t)] Q6. Consider a continuous-time LTI system described by dy(t)/dt + 2y(t) = x(t) + dx(t)/dt. Determine the: (i) transfer function (ii) frequency response (iii) impulse response of this system. Q7. Find the Fourier transform of the rectangular pulse signal x(t) given in Fig. 4. [Figure: Rectangular pulse signal between -a and a with amplitude 1] Then using duality property determine the Fourier transform of the signal x(t) = sin(at) / (pi t)