Continuous Signals and Linear Systems
EEE · Final · Summer 26
Paper 2 of 4Section B · Batch 253Switch
Section B · Batch 253
Paper 2 of 4
Read the questions as text
Read off the PDF by AI, so it may have mistakes. The PDF is the original.
Daffodil International University
Department of Electrical and Electronic Engineering
Faculty of Engineering
Final Examination, Summer - 2026
Course Code: 0714-217
Course Title: Continuous Signals & Linear Systems
Section: A, B, C, D, E, F, G
Level-Term: L2-T1
Teacher's Initial: MFI, SRH
Full Marks: 40
Exam Date: August 22, 2026
Time: 2 Hours
Answer all the following Questions
Q1. Determine the Laplace transform X(s) and illustrate the pole-zero plot with the ROC for the signal x(t) = e^(-3t)u(t) + e^(2t)u(-t). [CO-2, C(3), 5]
Q2. Consider the RC circuit shown in Fig. 1. The switch is closed at t = 0. Assume that there is no initial voltage on the capacitor. Using Laplace transform determine the step response of the following circuit.
[Figure: RC circuit with a DC voltage source v, a switch at t=0, a resistor R, and a capacitor C in parallel with output voltage v_c(t) and current i(t)] [CO-2, C(4), 5]
Q3. The output y(t) of a continuous time LTI system is found to be 2e^(-3t)u(t) when the input is a unit step function. Using Laplace transform Determine the output y(t) when the input x(t) is changed to e^(-t)u(t). [CO-2, C(4), 5]
Q4. Consider the periodic square wave x(t) shown in Fig. 2. Determine the complex exponential Fourier series and the trigonometric Fourier series of x(t).
[Figure: Periodic square wave x(t) with amplitude A, centered around t=0 from -T_0/4 to T_0/4, period T_0]
[CO-2, C(5), 5]
Q5. If h_1 = e^(-2t)u(t) and h_2 = 2e^(-t)u(t) then determine the overall impulse response h(t) for the continuous time LTI system given in Fig. 3.
[Figure: Block diagram of two parallel LTI systems h_1(t) and h_2(t) summing to form a total system h(t)] [CO-2, C(4), 5]
Q6. Consider a continuous-time LTI system described by dy(t)/dt + 2y(t) = x(t) + dx(t)/dt. Determine the: (i) transfer function (ii) frequency response (iii) impulse response of this system. [CO-2, C(4), 5]
Q7. Find the Fourier transform of the rectangular pulse signal x(t) given in Fig. 4.
[Figure: Rectangular pulse signal x(t) centered at origin from -a to a with height 1]
Then using duality property determine the Fourier transform of the signal x(t) = sin(at) / (pi*t).
[CO-2, C(4), 10]