Skip to content

Electronics II

EEE · Midterm · Fall 26

Paper 2 of 4Section C · Batch 253Switch

Section C · Batch 253

Paper 2 of 4

This browser can’t show the PDF here

Open it, and your phone’s PDF viewer takes it, or download it.

Read the questions as text

Read off the PDF by AI, so it may have mistakes. The PDF is the original.

Daffodil International University Department of Electrical and Electronic Engineering Faculty of Engineering Midterm Examination, Fall-2026 Course Code: 0714-221 Course Title: Electronics-II Section: : A,B,C,D,E,F,G Level-Term: L2-T2 Teacher's Initial: MH , RS , MMJ Full Marks: 25 Exam Date: October 31, 2026 Time: 1.5 Hours [Note: Answer all the questions. CO's represent one of the learning outcomes of the course. Figure on the right hand side indicate marks allocated for the question ] Q1. Explain the working of the op-amp circuit in Figure 1 as a Pulse Width Modulator (PWM). Using this explanation, determine Vs, Vs', Vk and ω so that the given output waveform is obtained. (From Figure1) CO-1 (C2) [5] [Figure: PWM op-amp circuit and output waveform Vo(t)] Q2. Calculate Output voltage of this circuit. (From Figure-2) CO-2 C(2) [5] [Figure: Multi-stage op-amp circuit] Q3. Calculate Voltage gain for the circuit below. (From Figure-3) CO-2 C(2) [5] [Figure: Op-amp circuit] Q4. Draw the output voltage waveform, vo(t). (From Figure-4) CO-2 C(2) [5] [Figure: Op-amp differentiator circuit and input voltage waveform Vi(V)] Q5. Design a closed-loop op-amp circuit to implement the equation CO-2 C(2) [5] 3 d^2Vo/dt^2 - 5 dVo/dt + 2Vo = 4Vi